Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ergo pull is a traditional-style cabinet pull for doors and drawer fronts, mounting on the most common cabinet hole pattern in North American kitchens.
The 3-3/4 inch center-to-center is the replacement pull of choice for stock cabinetry because the vast majority of cabinet makers drill to this spacing as a default. A kitchen full of existing hardware drilled at this spacing can swap to the Ergo pull without touching a drill. That matters on a refacing job, a rental refresh, or any room where the boxes stay and only the hardware changes. It also means that when a single pull breaks or goes missing, this is the size most likely to match what was already there.
The pull is cast in zinc and finished in Brushed Nickel. The brushed texture is what separates this finish from a polished one: the fine directional grain scatters light across the surface so the pull holds a consistent warm silver tone in changing kitchen light, rather than throwing a bright highlight when the overhead hits it. That behavior makes brushed nickel a reliable choice in kitchens where the light changes through the day or where the fronts are painted in a light neutral, because the hardware reads as a steady tone rather than as a mirror. Zinc is the material behind most cabinet hardware in this catalog, and it takes a Brushed Nickel finish cleanly and consistently across a set.
This pull suits cabinet installers and remodelers working with stock or semi-custom cabinetry already drilled to the 3-3/4 inch pattern. It suits homeowners refreshing a kitchen where the boxes are good but the pulls are dated, and designers specifying traditional hardware on shaker or raised-panel fronts where the Ergo profile's rounded posts fit the room's vocabulary. Because it belongs to the Ergo collection, the matching knobs in the same series and finish give a kitchen or bath a coordinated look when knobs go on doors and pulls go on drawers, which is the most common mixed-hardware approach in traditional interiors.
Yes, as long as the existing holes are centered 3-3/4 inches (95 mm) apart. Measure between the centers of the two holes, not from edge to edge, to confirm.
They are similar in tone but are distinct finish names from different manufacturers. Brushed Nickel is this pull's catalog finish, and it should not be assumed to match a Satin Nickel finish from another brand or series.
Yes. The 5-1/2 inch overall length and 1-1/8 inch projection suit both drawers and doors. The center-to-center spacing must match the holes already in the door.
The Ergo series includes companion pieces in the same design language and finish, so you can run pulls on drawers and matching knobs on doors from within the same collection.
Choose this pull when the holes are already there and the room calls for traditional hardware in a brushed silver that stays consistent from morning light to evening.
Sold In: 1 Each