Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Conga pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 3-3/4 inch centers and finished in Polished Nickel.
The 3-3/4 inch center-to-center is one of the most widely drilled cabinet hole patterns in residential cabinetry, which means this pull is a direct-fit replacement on any door or drawer front already bored to that spacing. It is also the natural choice for upper wall cabinet doors and shallower drawer fronts, where the 6-1/8 inch overall length sits in proportion without overwhelming the front. On a narrow door stile, the slim 7/16 inch bar width keeps the hardware from reading as heavier than the frame around it.
The pull is cast in zinc and finished in Polished Nickel, a bright mirror-like surface with a cool silver tone. Polished Nickel picks up and reflects ambient light, which makes it a natural complement to chrome faucets and brushed nickel fixtures already common in kitchens and baths. Where a matte or brushed finish recedes, a polished one sits forward, so this pull reads as a deliberate design element rather than a background detail. The Conga bar profile supports that quality: the narrow, squared section catches light along its full length and registers as a clean horizontal line across the face of the front.
This pull suits a contemporary or transitional kitchen, bath, or laundry room where the hardware program runs polished silver-tone metals. It is a practical fit for cabinet shops finishing production runs on standard-drilled boxes, for contractors sourcing hardware for a spec build where the hole pattern is already set, and for homeowners replacing worn or mismatched hardware on upper cabinets and small drawer banks. Because it belongs to the Conga collection, knobs on doors and pulls on drawers can be drawn from the same series, keeping the design language consistent across the whole room without mixing manufacturers.
Yes. The pull mounts on 3-3/4 inch (95 mm) centers. Measure between the centers of your existing holes to confirm the match before ordering.
They are similar in tone but not the same finish. Polished Nickel tends to carry a slightly warmer undertone than chrome and is a different plating process, so the two are close companions rather than guaranteed matches.
Yes. A bar pull works on both. The 3-3/4 inch spacing and 6-1/8 inch overall length make it well suited to upper wall doors and narrower drawer fronts in particular.
The Conga collection includes companion knobs and additional pull sizes in the same design language, so doors and drawers can be fitted from one series.
For cabinetry drilled to the 3-3/4 inch standard, this Conga pull brings a polished, light-catching finish to a clean contemporary bar form without requiring any new holes.
Sold In: 1 Each