Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Conga pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on one of the most common center-to-center spacings in residential cabinetry.
The 3-3/4 inch center-to-center is the workhorse spacing in cabinet hardware. It is the most frequently drilled hole pattern on standard base drawers and upper door pairs, which means this pull is often a direct swap when refreshing existing cabinetry without re-drilling. On a shaker or slab upper door it centers cleanly, and on a base drawer it provides a balanced grip across the front. The slim 7/16 inch bar does not crowd the front at this scale, keeping the hardware proportional without disappearing against the face.
The pull is cast in zinc and finished in Matte Black. A matte surface reads differently from a polished or brushed one: it absorbs light rather than reflecting it, so the pull holds a consistent flat black regardless of the angle or the light source in the room. That behavior makes it especially useful in kitchens with mixed or directional lighting, where a polished finish would shift in appearance across the day. The low-sheen surface also shows smudges and oil marks less readily than a polished black would, which matters on hardware that gets touched dozens of times a day.
This pull is built for a contemporary kitchen or bath where the hardware program is black and the priority is a clean, quiet look that does not compete with the cabinetry. It is a natural choice when replacing hardware across an existing bank of drawers already drilled on 3-3/4 inch centers, since no re-drilling is needed and the overall length is proportional to standard door and drawer widths. Designers specifying a full kitchen will find the Conga collection's companion pieces in the same series, making it straightforward to run this pull on drawers alongside matching knobs on doors without sourcing from two different lines.
Yes. The 3-3/4 inch spacing is the standard 96 mm cabinet hole pattern. Measure between the centers of your existing holes to confirm before ordering.
The bar is 7/16 inch wide in a flat profile, so the face sits flush and linear against the door rather than projecting a curved silhouette.
A matte surface is more forgiving than a polished one. It does not reflect oils as visibly, though regular wiping keeps any cabinet hardware looking its best.
The Conga series includes companion knobs in the same design language and Matte Black finish, so mixing pulls on drawers with knobs on doors is straightforward within the collection.
When the hole pattern is already there and the hardware program calls for a flat matte black, this pull resolves both requirements without compromise.
Sold In: 1 Each