Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Conga pull is a contemporary bar pull for cabinet doors and drawer fronts, sized to mount on one of the most common hole patterns in residential cabinetry.
Cabinet replacement projects hinge on one number: the distance between the centers of the two mounting holes already drilled in the door or drawer front. At 3-3/4 inches, this pull lands on the standard spacing that has dominated residential cabinet production for decades. That means it drops onto existing holes on most stock and semi-custom cabinet lines without any new drilling. For a kitchen refresh, a cabinet refacing job, or a rental turnover, that compatibility removes a step entirely. If the fronts are new and the holes have not been drilled yet, this spacing is also the most commonly specified starting point for a base drawer bank.
The pull is cast in zinc and finished in Polished Chrome, which produces a bright mirror surface along the flat bar face. Chrome is a reliable coordinating finish: it reads neutrally against white, gray, and wood-toned cabinetry and picks up the color of whatever light source hits it rather than imposing its own tone. The slim 7/16 inch bar width keeps the profile trim, so the hardware adds a line of polish to the front without thickening the visual. A polished surface does show fingerprints more readily than a brushed or matte finish, and it wipes clean just as easily.
This pull suits cabinet shops and contractors specifying hardware for a contemporary kitchen or bath where the hole pattern is already set at 3-3/4 inches and the finish program calls for chrome. It also suits homeowners replacing worn or mismatched hardware on an existing cabinet run, where dropping onto existing holes without drilling is the deciding factor. Designers mixing pulls on drawers with knobs on doors can coordinate through the Conga collection, which carries companion pieces in the same series and finish.
Measure between the centers of the two screws, or the two holes, on your current pull. If that measurement is 3-3/4 inches, this pull mounts without any additional drilling.
The bar is a narrow flat-face profile, 7/16 inch wide, so it sits trim against the door rather than projecting as a round cylinder would.
Polished Chrome is a mirror-bright surface, which reads differently from a brushed or satin texture. The two can work together in a room, but they are not the same finish and the visual difference will be visible up close.
Yes. The Conga collection includes other pull sizes and companion pieces in the same design language and finish, so doors and drawers can be matched within one series.
When the holes are already drilled at 3-3/4 inches and the finish program calls for a bright chrome bar, this pull is a direct, no-measurement fit for the job.
Sold In: 1 Each