Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Conga pull is a contemporary bar pull that mounts on 3-3/4 inch centers, a spacing found on the majority of standard cabinet door and drawer fronts. It suits installations where the existing holes are already drilled to that pattern, as well as new builds specifying a compact pull for upper doors and smaller drawer banks.
The 3-3/4 inch center-to-center is the workhorse spacing of residential cabinet hardware. Upper wall cabinet doors, narrow base drawers, and bathroom vanity doors are commonly drilled to this pattern, which makes this pull the natural choice when you are replacing existing hardware without re-drilling. On new cabinetry it lands well on doors up to roughly 15 inches wide and on drawer fronts in the same range, where a longer pull would feel oversized relative to the front. If the job calls for wider pulls on larger drawers, the Conga collection carries the same bar profile and Brushed Nickel finish at longer center-to-center spacings, so the hardware reads as one program across the full run of cabinetry.
The pull is cast in zinc and finished in Brushed Nickel. Brushed Nickel is a satin-silver finish with a fine directional texture that reduces visible reflections compared to polished chrome. In a kitchen or bath it coordinates naturally with stainless appliances and chrome plumbing fixtures without competing for attention. The slim 7/16 inch bar section keeps the profile light and linear, which lets the finish read as a clean accent rather than a substantial hardware object. Zinc provides good dimensional consistency across the production run, so the pulls align uniformly when installed across a full bank of doors and drawers.
This pull is a strong fit for designers and cabinet shops specifying a contemporary hardware program across a full kitchen or bath, where the 3-3/4 inch hole pattern is already established or is being set for the run. Homeowners replacing worn or dated hardware will find it a direct swap on cabinetry already drilled to this spacing. Contractors finishing spec builds or rental turnovers benefit from the Conga collection's consistent availability across sizes, so one series can cover every door and drawer on the job. The Brushed Nickel finish is also among the more neutral choices in the silver-tone family, which means it ages well without dating the room as finishes trend.
Center-to-center, 3-3/4 inches, is the distance between the centers of the two mounting holes and is the number you match to your existing holes or drilling template. Overall length, 6-1/8 inches, is the end-to-end size of the pull and governs how much room it takes up on the door face. They are two different measurements and should not be used interchangeably.
Yes. The 3-3/4 inch spacing and the standard 96 mm spacing are the same hole pattern, expressed in two unit systems. This pull mounts on either.
Brushed Nickel is a satin silver-toned finish that sits close to the tone of brushed stainless, and the two read comfortably together in most kitchens. An exact match is not guaranteed because the two finishes are produced differently, but the family relationship is close.
The Conga collection includes matching knobs and pulls in the same design language and Brushed Nickel finish, so you can mix knobs on doors and pulls on drawers within one consistent hardware program.
When the 3-3/4 inch hole pattern is already in place, or is being set across a full kitchen or bath, this pull closes the job cleanly without introducing a second hardware language to the room.
Sold In: 1 Each