Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Edge Pulls tab pull mounts on 12-5/8 inch (320 mm) centers, a span sized for wide base drawers, full-width drawer fronts, and the kind of oversized cabinetry where a shorter pull would disappear into the face.
The 12-5/8 inch center-to-center spacing is one of the largest standard hole patterns in cabinet hardware, and it earns its place on fronts wide enough that a shorter pull would leave the hardware looking undersized. Wide pot-and-pan drawers, full-width base drawers on islands, and tall pantry doors are the natural applications. On those fronts, a pull at this spacing runs close to the full usable width of the face, which anchors the hardware visually and gives the hand a long, natural grip across the span. Buyers replacing existing hardware on a 320 mm drilling pattern will find this a direct match; those specifying new cabinetry should confirm the drilling template before ordering.
The pull is extruded or machined from aluminum and finished in Matte Black. Aluminum at this length is a practical choice: it holds a straight, consistent profile across 13-1/4 inches without the flex risk that a thinner zinc section might carry at this span. The Matte Black finish is a low-sheen, non-reflective surface. Against light cabinet fronts it reads as a strong graphic line; against dark fronts it settles into the face and the geometry of the tab section does the work. The 1/2 inch width keeps the profile slim even at this length, so the pull contributes proportion without visual weight.
This pull is the right choice for a contemporary kitchen or built-in where the hardware program calls for long, flat pulls at a large spacing. It fits naturally on a wide island with a bank of deep drawers, on a tall pantry or cabinet column, or on any front wide enough to carry the 320 mm hole pattern comfortably. Because it belongs to the Edge Pulls series, companion pieces in the same collection are available to carry a consistent profile across narrower drawers and doors in the same project. Designers and cabinet shops specifying hardware across a full kitchen will find the series coordination useful for keeping the same tab profile and finish at multiple spacings.
Center-to-center is 12-5/8 inches (320 mm), the distance between the two mounting holes. That is the number to match to your existing drilling or your drilling template. Overall length is 13-1/4 inches (337 mm), the full end-to-end size of the pull, which is slightly larger and is the footprint on the door face.
Aluminum is a common material for cabinet hardware in kitchens. This pull is finished for indoor use.
1-3/4 inches (44 mm) from the face of the front to the back of the grip.
The Edge Pulls series includes companion pieces at other center-to-center spacings, so the same tab profile and Matte Black finish can carry through smaller drawers and cabinet doors in the same project.
Choose this pull when the cabinetry calls for a 320 mm hole pattern and the hardware should read as a flat matte line across the full width of the front.
Sold In: 1 Each