Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Edge Pulls tab pull mounts on 4-5/16 inch (109 mm) centers and delivers a clean, flat grip profile in Matte Black aluminum for cabinet doors and drawer fronts.
The 4-5/16 inch center-to-center is a mid-range spacing that suits a wide range of cabinet fronts without crowding a narrow drawer or getting lost on a wide one. On a standard upper door it sits comfortably centered, and on a mid-depth base drawer it leaves clearance on both sides of the pull. If you are replacing hardware drilled to this interval, this pull drops straight onto existing holes with no new drilling required. For fresh installs it is a practical middle-ground spacing that works across the main run of a kitchen or bath.
The pull is cast in aluminum and finished in Matte Black. Aluminum is lighter than zinc and takes a consistent matte surface well, which is part of why this profile reads so flat against the door. Matte Black absorbs light rather than reflecting it, so the pull stays visually subordinate to the cabinetry rather than competing with it. On light fronts it registers as a deliberate graphic line; on dark fronts it recedes into the face. Either way, it does not pick up glare from overhead lighting the way a polished finish would, which keeps the look clean in kitchens with strong task lighting.
This pull suits cabinet shops and designers specifying a contemporary kitchen, bath, or built-in where the hardware program is black and the fronts are flat-panel or shaker. The tab shape and narrow width make it a natural fit on drawer banks where a thinner profile is preferred over a full bar pull, and it works equally well on inset and overlay doors. Homeowners replacing hardware drilled to 4-5/16 inch centers will find this a direct swap with no additional prep. Because it is part of the Edge Pulls series, coordinating pieces in the same design language and finish are available to run knobs on doors while pulls cover the drawers.
Center-to-center is the distance between your two mounting holes, 4-5/16 inches (109 mm) on this pull. Overall length is the end-to-end size of the pull body, which is 5-1/8 inches (130 mm). Match your existing holes to the center-to-center figure, not to the overall length.
Yes. Aluminum is a lighter material than zinc, so this pull has a lighter hand feel at the same size. The difference is noticeable on a full drawer bank but does not affect function.
Matte Black finishes are generally more forgiving of fingerprints and smudges than polished surfaces, because the low sheen does not highlight oils the way a bright finish does.
The Edge Pulls series includes companion pieces in the same finish and design language, so mixing knobs on doors and pulls on drawers within the series is straightforward.
When the goal is a clean, contemporary cabinet face in matte black, this tab pull at 4-5/16 inch centers gives you the grip clearance you need without adding visual weight the cabinetry does not call for.
Sold In: 1 Each