Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Browning pull is a traditional bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers.
The 128 mm center-to-center spacing sits between the ubiquitous 96 mm and the wider 160 mm, which makes it the practical choice for mid-size drawer fronts and upper door panels where a 3-3/4 inch pull looks undersized but a 6-5/16 inch pull would overpower the front. It is a common factory hole pattern on base cabinets ordered in the 15 to 21 inch width range, which means it drops onto existing holes without any new drilling on a large share of kitchen renovations. When replacing hardware on a run of cabinets already drilled to this spacing, the fit is straightforward and there is nothing to measure beyond confirming the centers match.
The pull is cast in zinc and finished in Polished Nickel. A polished surface on nickel catches light along the full length of the bar, which sharpens the line and gives the pull a presence that a brushed or satin version would not. Polished Nickel coordinates well with chrome and with other bright silver-tone fixtures, and it holds its own against both warm and cool paint tones, which is one reason it remains a reliable specification in traditional kitchens. The bar is 11/16 inch wide, a proportional width for a traditional pull that avoids the slender look of a contemporary thin-bar profile.
This pull suits a traditional or transitional kitchen, bath, or built-in where the hardware program is bright silver and the cabinetry is dressed rather than minimal. The Browning collection is designed to coordinate across knobs, pulls, and companion pieces in the same series, so it is a workable starting point for a full kitchen hardware specification. For a cabinet shop or contractor outfitting a run of cabinets already drilled to 128 mm centers, this is the size to specify without a retrofit conversation.
The hole spacing is about 1-5/16 inches wider. If your existing holes are drilled at 3-3/4 inch (96 mm) centers, this pull will not drop in without new holes. Measure between the centers of your existing holes before ordering.
They are both bright silver-tone finishes but they are different surfaces. Polished Nickel has a slightly warmer, creamier tone than chrome, which tends to read cooler and bluer. They coordinate well in most settings but are not an identical match.
Yes. At 6-1/4 inches overall it suits both drawer fronts and door panels in a traditional kitchen. The sizing convention of matching pull length to roughly a third of the front width is a common design guide, though it is a preference rather than a requirement.
The Browning series includes companion pieces in the same design language and finish, so you can pair knobs on doors with pulls on drawers within the same collection.
Choose this pull when the cabinetry is already drilled to 5-1/16 inch centers, or when a mid-size traditional bar pull in Polished Nickel is the right scale for the door or drawer it lands on.
Sold In: 1 Each