Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Browning pull is a traditional bar pull designed for cabinet drawers and doors where a 5-1/16 inch center-to-center spacing is the standard or the replacement requirement.
The 5-1/16 inch (128 mm) center-to-center dimension is the key number here. It governs where the drill hits the door or drawer front, and it is the measurement that determines whether this pull drops onto existing holes or requires new ones. At 128 mm it falls between the common 96 mm and 160 mm spacings, making it a frequent spec on mid-scale base drawers, pantry doors, and full-height upper cabinets. If the existing holes measure 5-1/16 inch between centers, this pull installs without touching the drill. If not, the 6-1/4 inch overall length gives enough face coverage to span a repaired hole from a previous pull if the centers are being moved.
The pull is cast in zinc and finished in Brushed Nickel. Brushed Nickel is a mechanically textured silver-tone surface: the brushing creates a fine linear grain that diffuses light instead of reflecting it as a sharp highlight. On a bar pull the result is a finish that reads as a warm silver under incandescent light and a cooler silver under daylight, with enough texture to stay consistent as the light in the room changes. It also tends to show smudges less readily than a polished surface, which matters in a kitchen where the hardware is touched dozens of times a day.
The Browning collection carries a Traditional design style, which makes this pull a natural fit for raised-panel kitchens, inset cabinetry, furniture-style islands, and bathroom vanities where the hardware is expected to complement wood detail rather than contrast with it. The Brushed Nickel finish coordinates with stainless appliances, brushed nickel faucets, and similar silver-tone fixtures without the warmth of brass or the severity of black. Designers who are mixing knobs on doors and pulls on drawers will find the companion Browning knobs in the same series and finish, so the hardware program can be built from one collection.
Measure from the center of one mounting hole to the center of the other. If that measurement is 5-1/16 inches, this pull mounts without any new drilling.
The grip is a bar pull at 11/16 inch wide. The Browning profile has a traditional character suited to detailed cabinetry rather than a minimal modern look.
Finish names are not standardized across manufacturers. The Top Knobs Brushed Nickel may read similarly to other brushed nickel hardware, but a visual comparison in person is the only reliable way to confirm a match.
Yes. A bar pull at this scale is commonly used on both drawer fronts and cabinet doors wherever 5-1/16 inch centers are appropriate.
When the cabinetry is already drilled at 128 mm and the finish program calls for brushed nickel, this Browning pull resolves both requirements in one piece.
Sold In: 1 Each