Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Elizabeth pull is a transitional cabinet pull sized for the 5-1/16 inch (128 mm) center-to-center hole pattern, a spacing that lands squarely in the range of base drawers, upper doors, and vanity fronts across most kitchen and bath layouts.
The 5-1/16 inch center-to-center spacing is one of the handful of drill patterns that appear on pre-drilled cabinet cases from nearly every major manufacturer. If your existing hardware or your new cabinets are drilled at 128 mm, this pull drops onto those holes without a template. That removes a step from an install and removes a variable from a reorder. For a mid-width drawer in a base run, a center drawer on a wall cabinet, or a single-door vanity, this spacing is often the one that was already decided for you before the first screw went in.
The Elizabeth pull is a slender bar at 7/16 inch wide, and the Polished Chrome finish runs as a continuous bright line across that face. Chrome at this scale coordinates cleanly with faucet trim, appliance handles, and light fixtures without competing with the cabinetry itself. It suits a kitchen or bath where the metal program is already chrome-based and the new hardware needs to join that palette rather than introduce a second finish into the room. The zinc body holds its shape under the plating, and the slim profile keeps the pull from reading as heavy against a flat-front or shaker door.
The Elizabeth collection is built around a transitional design language, which means it works in both a contemporary flat-panel kitchen and a more traditional raised-panel setting without looking out of place in either. A 5-7/8 inch bar in Polished Chrome at this projection is a practical choice for a designer specifying a complete hardware program, a cabinet shop pulling from stock for a production run, or a homeowner replacing existing pulls that are already drilled at 128 mm. Because the Elizabeth series includes companion knobs, other pull lengths, and appliance pulls in the same design language and finish, it is straightforward to mix pull sizes on drawers and doors within a single room without breaking the visual consistency of the hardware set.
Yes. If your existing holes are centered 5-1/16 inches apart, this pull mounts directly onto them. Measure between hole centers on your current hardware to confirm before ordering.
The bar is 7/16 inch (11 mm) wide, which gives it a slim, refined profile rather than the chunkier look of a wider bar pull.
A polished surface will show prints more readily than a brushed or matte finish. It also wipes clean easily, so it stays presentable with routine maintenance.
The Elizabeth series is available in multiple center-to-center sizes in Polished Chrome, so you can run a longer pull on a wide drawer or an appliance panel and keep the same finish and design language throughout.
When the hole pattern is 128 mm and the finish program is chrome, the Elizabeth pull closes the hardware decision without a special order or a re-drill.
Sold In: 1 Each