Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Bronte pull is a traditional bar pull for cabinet doors and drawer fronts, mounting on the most common cabinet hole pattern in residential kitchens.
The 3-3/4 inch center-to-center dimension is the pull spacing that shows up most often on factory-drilled cabinet boxes. A buyer replacing hardware in an existing kitchen, a contractor refreshing a rental, or a shop specifying a standard base cabinet all land on 96 mm as the first hole pattern to confirm. Because this pull mounts exactly on that spacing, it installs directly onto existing holes without any new drilling. The 5-1/16 inch overall length gives the bar a small overhang past the posts, which is the proportion that looks intentional on a standard drawer front rather than undersized or forced.
The pull is cast in zinc and finished in Polished Chrome. Chrome at this level of polish runs as a bright, even line along the flat bar face, which means it reads as a highlight against both light and dark cabinet fronts. It is the finish most likely to match an existing faucet, towel bar, or appliance trim already in the room, which is exactly why it is the low-friction choice when a project calls for a neutral metal that does not compete with the cabinetry. The bar itself measures 11/16 inch across, keeping the profile slim enough that the grip sits close to the front without adding visual bulk.
This is the pull for a traditional or transitional kitchen where the hardware needs to coordinate with existing chrome or polished fixtures rather than introduce a second metal. It is equally practical for a full cabinet replacement, a door-and-drawer refresh on an existing box, or a spec job where the builder wants a proven hole spacing and a finish that photographs cleanly for listings. The Bronte collection carries companion knobs and pulls in the same series, so mixing knobs on doors and pulls on drawers is a straightforward decision rather than a sourcing exercise.
Measure between the centers of the two existing screw holes. If that distance is 3-3/4 inches (96 mm), this pull drops onto the existing pattern without new drilling.
A polished surface picks up marks more readily than a brushed or matte finish and wipes clean just as easily. On a high-traffic drawer it is worth keeping a soft cloth nearby.
Yes. The Bronte collection is designed so knobs and pulls share the same design language and finish, making the combination straightforward on a kitchen where doors take knobs and drawers take pulls.
The grip has a bar profile that is 11/16 inch wide, giving it a squared rather than fully round cross-section. It sits close to the cabinet face without adding bulk.
Choose this pull when the hole pattern is already drilled at 96 mm and the finish should be a bright chrome that coordinates with the fixtures already in the room.
Sold In: 1 Each