Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Wide Square pull is a contemporary D-handle pull for cabinet doors and drawer fronts, sized to mount on the most common cabinet hole spacing in the market.
On a replacement or refacing project, 3-3/4 inch (95 mm) centers means no new drilling on the vast majority of existing cabinet cases. That spacing is the standard across decades of domestic cabinetry production, so a pull that matches it drops onto existing holes on upper doors and mid-size drawers without touching a drill. For a shop fitting a run of new boxes to the same standard, it aligns with the most widely available drilling jigs and templates. Either way, the hole pattern is the first fit decision on any pull order, and this one removes it as a decision entirely for most kitchens.
The Wide Square pull is cast in zinc and finished in Polished Chrome. The polish runs bright and even across the squared grip and down the returns, so the chrome reads as a continuous reflective line rather than picking up directional grain the way a brushed finish does. That brightness is what makes polished chrome the natural companion to stainless appliance fronts, chrome faucets, and recessed light trims: the kitchen is already running that finish family, and matching it in the cabinet hardware closes the room rather than fragmenting it. The D-handle form, where the grip bar returns fully to the door face at both ends, sits closer to the front than an open-post bar pull and gives the pull a more enclosed, furniture-like silhouette.
This pull suits contemporary and transitional kitchens where the fixtures are already chrome or polished metal and the cabinetry is slab or shaker. At 5-1/8 inches overall it is sized for mid-width base drawers, upper doors, and vanity fronts, where the hardware should read clean and proportional rather than oversized. Designers specifying a full kitchen can run this pull on drawers and coordinate with a matching knob from the Wide Square collection on doors, keeping the geometry consistent across the entire hardware program. Cabinet shops and contractors sourcing for a spec build or a rental unit will find the standard spacing a direct production advantage.
Yes. The 3-3/4 inch spacing is the same standard cabinet hole pattern whether it is listed as 95 mm or 96 mm. The two values reflect a rounding difference in conversion, not a difference in the physical hole spacing. This pull mounts on the same centers as any 3-3/4 inch pull.
A bar pull carries an open bar on two posts, with a gap between the grip ends and the door face. A D-handle returns the grip fully to the surface at both ends, enclosing the opening. The result is a more contained silhouette and a slightly shorter projection from the door face.
A polished surface picks up marks more readily than a brushed or matte finish. It also wipes clean easily, so it stays presentable with routine wiping.
Yes. The Wide Square collection includes companion knobs and other pull sizes in the same design language, so you can coordinate doors and drawers within the same series.
When the project calls for polished chrome hardware on a standard 3-3/4 inch hole pattern, this pull resolves both requirements at once without compromise on the form or the fit.
Sold In: 1 Each