Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Elizabeth pull is a transitional bar pull for cabinet doors and drawer fronts, sized at 3-3/4 inch center-to-center, the spacing that drills into more existing cabinets than any other.
Most cabinet door and drawer hardware is drilled at 3-3/4 inch centers from the factory, which makes this pull the straightforward answer for a refit, a renovation update, or a replacement where the fronts are staying put and the hardware is changing. No new holes, no filler, no patching. The center-to-center lands on the existing pattern and the job moves forward. At 4-9/16 inches overall the bar spans a comfortable grip length on a standard drawer, with enough material on either side of the holes to look intentional rather than tight.
The pull is cast in zinc and finished in Matte Black. Where a polished or satin black reads reflective and shows the light source in the room, a matte surface absorbs it and stays even across the bar. That quality makes matte black easier to pair with mixed lighting, and it tends to show fewer marks in daily use than a high-sheen alternative. The slim 7/16 inch bar width keeps the profile from reading as heavy on the front, which is useful when the goal is to update the hardware without making the hardware the first thing you see in the room.
This pull suits a transitional kitchen, bath, or built-in that is running black hardware and needs the standard 3-3/4 inch spacing covered. It works equally on a slab front and a shaker-style door, because the narrow bar does not compete with either profile. Cabinet shops running production kitchens in black hardware, designers specifying a refresh without altering the boxes, and homeowners replacing dated brass or chrome on existing cabinetry all land at this pull for the same reason: the spacing is right and the finish is clean. The Elizabeth collection supports a coordinated installation, with knobs available in the same series and finish for door fronts alongside pulls on the drawers.
They are the same standard 3-3/4 inch hole spacing encoded two ways in different catalogs. Hardware at 3-3/4 inch centers will fit both, and you should measure your existing holes in inches rather than chasing the millimeter figure.
The projection is 1-1/4 inches (32 mm), measured from the face of the front to the back of the grip bar.
Yes. The 3-3/4 inch spacing and the 4-9/16 inch overall length suit both a drawer front and an upper cabinet door at standard widths.
The Elizabeth series includes companion knobs in Matte Black, which is the standard way to run pulls on drawers and knobs on doors within one coordinated hardware program.
When the existing drill pattern is 3-3/4 inch and the finish direction is matte black, this pull resolves both requirements without compromise.
Sold In: 1 Each