
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
The Quickscrews M4 x 35mm truss head machine screw is a fine-thread fastener for mounting cabinet knobs, pulls, and decorative hardware to doors and drawer fronts. The 35mm length covers typical door and drawer front stock with room to thread fully into the hardware base, and the wide, low-profile truss head spreads clamping load across the face without protruding.
Cabinet doors and drawer fronts vary in thickness, and the screw length has to clear the stock before threading into the hardware. At 35mm, this screw works well through standard 3/4-inch (19mm) door stock with a hardware base that accepts the remaining thread engagement — a common configuration in kitchen and bath cabinetry. It also suits slightly thicker drawer fronts or doors with a decorative overlay where a shorter screw would fall short of full thread engagement in the knob or pull. If the combined stack of door material and hardware base is closer to 25mm, the 30mm sibling is the better fit; if the installation runs deeper than 40mm, step up to the 45mm length instead.
The truss head sits wide and low against the mounting surface, which keeps the fastener inconspicuous on the interior face of a door or drawer front while still pulling the hardware tight. Fine thread on an M4 shank is the standard for metric cabinet hardware — it threads cleanly into pre-tapped knob and pull bases without the risk of cross-threading that a coarser pitch can introduce in small hardware fittings. The zinc finish is appropriate for cabinet interiors and other dry indoor environments where standard corrosion protection is sufficient.
Hardware installers working through a kitchen or bath project will find the combination drive useful — a #2 Phillips is the default, and the slotted option covers situations where only a flat-blade is available. Designers specifying metric hardware can call out this screw by Quickscrews part number 10952 with confidence that the M4 fine thread will mate with hardware from European and metric-standard manufacturers. Cabinet shops running moderate volume will get through a standard project on a single box of 100 without reordering mid-job.
The screw has to pass through the door or drawer front thickness before it threads into the hardware base. A 35mm screw clears standard 3/4-inch stock and still provides enough thread engagement in the knob or pull to seat it firmly. Too short and the screw won't reach full engagement; too long and it bottoms out before the hardware is tight.
Most European and metric-spec cabinet hardware is pre-tapped for M4 fine thread. The fine pitch gives clean, precise engagement in small-diameter tapped holes and is less prone to cross-threading than a coarser pitch would be in a tight hardware fitting.
Yes. The combination drive accepts a #2 Phillips bit. The slotted groove is there as a secondary option if a flat-blade driver is the only tool available on the job.
The truss head sits low and wide, so it bears against the face without a large protrusion. On the back face of a door or drawer front — which is the typical installation side — it stays out of view and doesn't interfere with adjacent hardware or the cabinet interior.
The zinc finish is rated for dry indoor use. For installations in high-humidity areas or exterior applications, a stainless or higher-rated finish is the better choice.
When the screw length, thread standard, and head profile all match the hardware and stock thickness, installation is straightforward and the hardware seats correctly the first time. The Quickscrews M4 x 35mm truss head machine screw is sized and threaded to do exactly that for standard cabinet door and drawer front hardware in metric specifications.
Sold In: 100 Each