Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Pro Value Mission Columns split column is a decorative applied column in maple, sized for raised-bar applications and finished cabinet ends.
At 42 inches, this column is sized for the raised portion of a kitchen island, a peninsula bar end, or a tall cabinet run where the upper section meets a raised countertop or bar overhang. The 36 inch version suits standard counter height; this one is the answer when the design calls for a bar rail or a raised work surface. It is a common application, not a fit guarantee, because the finished height depends on the countertop thickness and the base, which the column itself does not determine.
The column is 3-1/2 inches wide and 1-3/4 inches deep. That depth-to-width ratio tells the whole story: this is an applied half-section that presents a full column face while sitting just under two inches off the panel. The chamfered bar profile means the corners are clipped back at an angle rather than fully rounded or left square, which is a signature of Mission-style joinery and keeps the piece in register with frame-and-panel cabinetry built in that tradition. The material is maple, supplied unfinished, which is the common choice when the surrounding cabinetry is also maple, because the column can be finished alongside the cabinet rather than matched to it after the fact.
Cabinet shops building or retrofitting Mission-style kitchens, designers specifying column details for raised island ends, and contractors finishing a peninsula or bar panel will all reach for this piece. It is also a natural fit for furniture-style cabinetry where a clean vertical break at the end of a run matters. Because it is a split section, it installs against an existing panel rather than requiring the framing to be built around a full column footprint.
The depth. At 1-3/4 inches, the piece is a fraction of the full 3-1/2 inch width, which means it applies flat to a cabinet end panel and reads as a column face without occupying a full column's footprint.
No. It is a decorative applied piece with no load rating. For structural support under a countertop overhang, a rated support system is required separately.
Species choice is driven by the surrounding cabinetry. Maple is a dense, fine-grained wood that finishes predictably and is widely used in production cabinetry programs. If the adjacent doors and frames are maple, ordering the column in maple keeps the grain and density consistent before finishing.
Unfinished. It leaves the finishing to the installer, which is standard for applied column trim that needs to match on-site.
Choose this column when a bar-height island or raised cabinet run needs a clean Mission-style vertical finish at the exposed end, without giving up the panel depth a full column would require.