Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Pro Value bun foot is a decorative wood foot for cabinets, vanities, islands, and furniture bases where a classic square profile suits the style of the surrounding cabinetry.
Classic-style bun feet work by mass and proportion rather than by ornamental detail. Where a transitional foot might taper and a mission foot might chamfer, the classic square section reads as grounded and deliberate. At 4-5/8 inches wide on each face, this foot is a substantial presence at the base corner of a cabinet, not a thin bracket. Paired with a furniture-style base or a frame-and-panel door program, it reinforces the cabinet's weight and permanence rather than competing with it. The 4-1/2 inch height creates a visible gap between the cabinet bottom and the floor, which shifts the visual reading from built-in to freestanding.
Cherry is a fine-pored hardwood that takes both clear finishes and stains with consistency, and it is a common species in higher-end cabinetry programs. Supplying the foot unfinished means the finish can be matched to the surrounding case work in the shop rather than approximated from a pre-finished catalog. The foot is ordered in cherry specifically because the cabinetry it goes under is cherry, or because cherry will stain to sit alongside it, not as a generic wood foot. No finish is applied and no stain result is stated, because those are shop decisions.
This foot suits a furniture-style bath vanity, a free-standing base cabinet, a kitchen island with finished ends, or a standalone piece being built or refitted with classic styling. It is a decorative wood foot and carries no stated load rating. Buyers specifying for a project where a classic square foot with substantial proportions fits the design program, and where the surrounding work is in cherry or will be finished to coordinate with it, are the audience this foot is stocked for.
The square section is symmetrical, so a single foot works at any corner position without a left or right orientation.
It is on the larger end of the range in this program. The square footprint reads as a block rather than a knob, which suits cabinets with a heavier visual weight.
It is the same species, which is the starting point. Exact matching across separate pieces is a shop finishing question; the foot is supplied unfinished so the stain and topcoat can be applied in the same batch as the surrounding work.
The source data does not state what hardware, if any, ships with this foot.
Choose this foot when the design calls for a classic square profile, the species is cherry, and the finishing will happen in the shop alongside the rest of the piece.