Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Atwood pull is a contemporary rectangular bar pull that mounts on 5-1/16 inch (128 mm) centers, a spacing well suited to mid-width drawer fronts and standard upper cabinet doors.
The 5-1/16 inch center-to-center is one of the most widely used pull spacings in residential cabinetry, and it shows up frequently on base drawers in the 18 to 24 inch range, on upper door stiles, and on vanity drawer fronts. If you are replacing existing hardware, measure between the centers of the two current holes before ordering. A pull drilling new holes should treat this spacing as the drilling dimension, not the overall length of 6-3/8 inches. The two numbers are different, and confusing them means drilling in the wrong place.
Unlike most pulls in this catalog, which are cast zinc, the Atwood is made from aluminum. Aluminum runs lighter than zinc at comparable sizes, which is noticeable in hand on a wider pull. The Matte Black finish is a flat, even black with no sheen, so it does not reflect kitchen light or amplify fingerprints the way a polished finish does. The finish sits well against white and light-painted cabinetry, where a black pull creates a deliberate contrast, and equally well against darker fronts, where the pull blends into the overall palette rather than standing apart from it.
This is a practical choice for a contemporary kitchen or bath where the hardware program is already black or where Matte Black is being introduced as the metal for the first time. Designers specifying a full kitchen often run this size on upper doors while stepping up to a longer Atwood pull on wider base drawers, keeping the same collection and finish throughout so the room reads as one decision rather than several. Cabinet shops and contractors working a spec build or a repeat floor plan will find the 128 mm spacing installs quickly on standard drilling patterns with no layout surprises. Because it is part of the Atwood collection, matching knobs and companion pull lengths are available in the same series.
The 5-1/16 inch (128 mm) figure is the drilling dimension, the distance between the centers of the two mounting holes. The 6-3/8 inch overall length is the end-to-end size of the pull. Always drill or match to the center-to-center measurement, not the overall length.
The Atwood series uses aluminum as its base material, which runs lighter than the zinc alloy used in most pulls at this price point. The structural performance is comparable for cabinet use.
A flat matte surface is less prone to showing fingerprints visibly than a polished or high-sheen finish. Routine wiping keeps the surface looking even.
Yes. The Atwood series includes knobs and pulls in multiple center-to-center sizes, all in the same design language and Matte Black finish, so you can mix knobs on doors with pulls on drawers within one collection.
When the front is too wide for a 3-3/4 inch pull but a longer pull would overscale it, the 5-1/16 inch Atwood lands at exactly the right point: substantial enough to read on a mid-width drawer, tidy enough not to dominate it.
Sold In: 1 Each