Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Bronte pull is a traditional bar pull for cabinet doors and drawer fronts, mounting on 3-3/4 inch (96 mm) centers — one of the most widely drilled spacings in residential cabinetry.
When swapping out hardware on an existing kitchen or bath, the center-to-center measurement is the number that matters. Drawers and doors already drilled to 3-3/4 inch centers accept this pull without touching a drill, which makes it the most practical option for a refresh or a full replacement run across a standard cabinet bank. At 5-1/16 inches end to end, the pull reads as proportional on mid-width drawer fronts and upper door stiles without overwhelming the face of the cabinet.
The Bronte pull is cast in zinc and finished in Matte Black. The matte surface holds a flat, even tone across the bar without picking up the highlights or showing the reflection variation that a polished finish would. On light-colored cabinet fronts the black reads as a deliberate graphic line. Against darker wood or painted fronts, it recedes into the cabinetry and lets the doors and drawer faces do the visual work. Either way, the low sheen keeps the hardware from competing with the room.
This is a straightforward choice for a traditional or transitional kitchen, bathroom vanity, or built-in where the hardware program is black and the existing hole pattern is 3-3/4 inches. Designers specifying a new run of cabinetry will find the Bronte series provides matching knobs for doors alongside pulls for drawers, so the full hardware program comes from one collection. For cabinet shops completing a kitchen or bath install, the 96 mm spacing means this pull lands on the most common factory-drilled pattern with no adjustments needed on site.
Yes. Measure between the centers of your existing holes. If that distance is 3-3/4 inches (96 mm), this pull mounts directly without additional drilling.
The finish is applied over a zinc base. It presents as a flat, low-sheen black rather than a glossy or polished surface.
The Bronte series includes companion knobs and pulls in the same design language and finish, so you can coordinate doors and drawers within one collection.
The bar section is 11/16 inch wide, giving the grip a slim, refined profile rather than a thick, bold one.
When the existing hole pattern is 3-3/4 inches and the hardware program is black, the Bronte pull is a clean, no-compromise fit for traditional and transitional cabinetry.
Sold In: 1 Each