Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Bronte pull is a traditional bar pull for cabinet doors and drawer fronts, mounting on one of the most common hole spacings in residential cabinetry.
The 96 mm center-to-center spacing is the single most common drilling pattern on factory-built and custom cabinetry in North America. A drawer bank drilled to this spacing can take this pull without touching a drill, which makes it the practical choice for a hardware refresh, a renovation update, or finishing a spec build where the holes are already in. At 5-1/16 inches overall, the bar extends past the posts with enough visual length to register on a mid-width drawer front without overwhelming a standard upper door. The slender 11/16 inch width keeps the bar in proportion on shaker and recessed-panel fronts where a thicker section would look heavy.
The pull is cast in zinc and finished in Cafe Bronze, a warm, mid-depth bronze tone with a muted surface that reads as bronze rather than brown or copper. On painted fronts in whites, creams, and warm grays, Cafe Bronze settles in as an accent without the high contrast of a dark matte or the glare of a polished metal. On stained wood it picks up the warm undertones in the grain rather than fighting them. The brushed quality of the finish means it does not telegraph every fingerprint the way a polished surface does, which matters in a kitchen that gets daily use. Because this is a Bronte collection piece, the same finish name on the companion knobs and pulls in the series will carry the same surface treatment.
This pull is a strong fit for traditional and transitional kitchens, bathroom vanities, butler's pantries, and built-in cabinetry where the hardware program calls for a warm bronze tone without going to an oil-rubbed or antique finish. Designers specifying a full kitchen will find the 96 mm spacing straightforward to coordinate across a range of door and drawer sizes, and cabinet shops replacing hardware on an existing build can swap these in without redrilling. The Bronte collection supports a mixed-hardware approach where pulls go on drawers and knobs go on doors, all within the same series and finish.
Measure from the center of one hole to the center of the other. If that measurement is 3-3/4 inches (96 mm), this pull drops in without any new drilling.
It is a mid-tone warm bronze, warmer and lighter than an oil-rubbed bronze but richer than a light satin brass. It is not a painted or coated finish.
Yes. Because both are Bronte collection pieces in Cafe Bronze, the finish and design language will coordinate across doors and drawers.
It installs through the door or drawer front with machine screws from the back, the same as any standard two-hole cabinet pull. Screw length depends on the thickness of your front.
For a kitchen or bath refresh where the holes are already drilled to 96 mm, this Bronte pull in Cafe Bronze brings a traditional warm-metal look to the job without the complication of redrilling.
Sold In: 1 Each