Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Bronte pull is a traditional bar pull for cabinet doors and drawer fronts, centered on a 5-1/16 inch (128 mm) hole pattern and finished in Warm Brass.
The 5-1/16 inch center-to-center dimension is the number that drives the purchase decision here. It is the distance between the centers of the two mounting holes, and it has to match what is already drilled in the door or drawer front. A 6-1/4 inch pull mounts on 5-1/16 inch centers, not 6-1/4 inch centers, and confusing the two is the most common reason a pull comes back. If the existing fronts are drilled to this spacing, this pull drops straight onto them. If the project is new construction, this spacing suits a wide drawer or a taller door panel without looking undersized.
The pull is cast in zinc and finished in Warm Brass. Warm Brass is a muted, slightly darkened gold tone that sits between a polished brass and an antique brass in appearance. It has enough warmth to read clearly against painted or stained wood fronts without the high glare of a fully polished surface. In a traditional kitchen or bath, that restraint matters: the hardware should belong to the room rather than compete with it. The 11/16 inch bar width keeps the profile slim, so the pull reads as a line rather than as a separate object on the door face.
This pull fits well in traditional and transitional kitchens, bathrooms, and built-in furniture where the hardware program is running a warm gold tone. The 5-1/16 inch spacing is particularly common on larger drawer fronts and on taller door panels, which makes this a practical choice for a full kitchen where the mid-size drawers and wall cabinet doors need a consistent pull without stepping up to a longer bar. Because it belongs to the Bronte collection, companion knobs and pulls in the same series carry the same design language and finish, which is the straightforward way to mix knobs on doors and pulls on drawers without introducing a visual mismatch.
The mounting dimension is 5-1/16 inches (128 mm), measured between the centers of the two holes. The 6-1/4 inch figure is the overall end-to-end length of the pull, which is larger.
Warm Brass sits between the two. It is not a high-gloss polished brass, and it is not a flat matte. It has a soft sheen that reads warm without picking up sharp reflections under kitchen lighting.
Yes. This is a standard bar pull and works on both cabinet doors and drawer fronts. The 5-1/16 inch spacing is common on upper cabinet doors as well as mid-size drawer banks.
The Bronte series includes companion hardware in the same design language and finish. Look for matching knobs and pulls within the collection to coordinate a full kitchen or bath program.
When the drawer bank is drilled to 5-1/16 inch centers and the room calls for a warm gold tone, this pull is the specific fit rather than a close approximation.
Sold In: 1 Each