Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Erika pull is a transitional bar pull for cabinet doors and drawer fronts, mounted on 6-5/16 inch (160 mm) centers.
The 160 mm center-to-center is a step up from the 128 mm pull that suits mid-width base drawers, landing instead in the range where the front is wide enough to warrant a longer bar. A deep pot drawer, a 24-inch-wide utility drawer, or a full-height pantry door all fall naturally at this scale. The pull reads as proportional rather than undersized, and the slim 3/8 inch bar keeps the profile from competing with the cabinetry. For designers who apply a one-third proportion rule, this spacing commonly pairs with fronts in the 18 to 24 inch range, though that is a design convention rather than a product specification.
The pull is cast in zinc and finished in Brushed Nickel, a muted silver-tone surface that diffuses light rather than reflecting it as a sharp highlight. That quality makes it forgiving in kitchens with mixed or directional lighting, where a polished finish would pick up every change in the room. Brushed Nickel is also one of the most cross-compatible finishes in kitchen and bath hardware, sitting comfortably alongside stainless appliances, chrome plumbing fixtures, and other silver-tone metals without demanding an exact match. Within the Erika collection it maintains consistent color and texture across pulls, knobs, and companion pieces in the same series.
This pull suits transitional kitchens, baths, and built-ins where the hardware needs to bridge traditional cabinetry forms and contemporary flat profiles without committing fully to either. The Brushed Nickel finish and the slim bar section read cleanly on shaker doors, on slab fronts with visible grain, and on painted inset cabinetry alike. It is a practical specification for cabinet shops running mixed door styles in a single kitchen, and for designers building a hardware program that will hold up across future renovations without dating the room. Because this is an Erika series piece, companion knobs, pulls at other center-to-center spacings, and backplates in the same finish are available within the collection to complete the program.
The source data does not confirm included hardware. Standard 8-32 machine screws are the typical fastener for this pull type; screw length should match your door or drawer front thickness.
Measure from the center of one hole to the center of the other on your existing pull. If that figure is 6-5/16 inches (160 mm), this pull mounts without new drilling.
Brushed Nickel coordinates well with stainless and other silver-tone fixtures, but finish names are not standardized across manufacturers. The closest match is always confirmed by holding a sample alongside the existing hardware before committing.
Yes. The Erika series spans multiple center-to-center spacings in Brushed Nickel, so you can mix pull lengths across a kitchen while keeping a consistent finish and profile.
When the drawer or door is wide enough that a 5 inch pull looks lost, this 160 mm spacing fills the front with a bar that earns its place without overwhelming the cabinetry around it.
Sold In: 1 Each