Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Erika pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers.
The 5-1/16 inch (128 mm) center-to-center is one of the most common hole patterns in kitchen and bath cabinetry. It sits comfortably on a 15-inch base drawer, a mid-size pantry door, and a standard upper cabinet door without looking undersized or crowded. When replacing existing hardware, this spacing matches many of the most widely used factory drilling patterns, so the holes are often already there. The pull's 5-7/8 inch overall length gives a few extra millimeters of visual length on each side of the posts, which helps it read as a considered hardware choice rather than a minimally sized one.
The Erika pull is cast in zinc, which produces a dense, even base well suited to a matte finish that needs to stay consistent across an entire hardware run. Matte Black holds its surface under kitchen light without picking up highlights or hot spots the way a polished finish does. The 3/8 inch width keeps the bar slim, which lets the flat face sit close to the front and maintain the lean geometry the Erika series is built around. Against painted white or gray fronts the black reads as a deliberate contrast element. Against darker cabinetry it integrates into the surface and lets the door or drawer do the visual work.
This pull is a natural fit for kitchen remodels and new builds where the hardware program is black and the cabinetry runs from transitional to contemporary. Because the Erika series includes companion knobs and additional pull lengths, a single project can draw the door hardware and the drawer hardware from the same collection and keep the design language unified. It is also a practical choice for cabinet shops specifying hardware across multiple units: the 128 mm spacing is shared by enough cabinetry lines that the same pull can often run across base cabinets, uppers, and tall pantry columns without a separate SKU for each.
Yes. 5-1/16 inches converts to 128 mm. Both values refer to the same hole spacing, and either measurement can be used to confirm a match with existing holes.
Measure from the center of one existing hole to the center of the other. If that distance is 5-1/16 inches or 128 mm, this pull drops onto your current drilling with no new holes needed.
The Erika bar is 3/8 inch wide, giving it a slim, flat-faced profile rather than a rounded cross-section.
The Erika series includes companion knobs in the same design language. Using pulls on drawers and knobs on doors from the same series keeps the finish and profile consistent across the job.
A matte surface shows marks less readily than a polished one and wipes clean with a damp cloth. It will not develop the mirror-like smudge pattern that a high-gloss black finish can.
When the hole spacing is already there and the finish needs to run clean from door to drawer, this pull is the one to reach for.
Sold In: 1 Each