Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Erika pull is a transitional cabinet pull designed for doors and drawer fronts where the mounting holes are spaced 3 inches apart.
Three inch center-to-center is the standard hole pattern on most upper cabinet doors and on narrower drawer fronts. If you are replacing existing hardware without re-drilling, confirming this spacing against your current holes is the single most important step before ordering. For a door bank or a drawer run already drilled to 76 mm, this pull drops onto the existing pattern. The 3-7/8 inch overall length gives the pull a modest footprint on smaller fronts, which keeps the hardware from visually overpowering a narrow door stile or a thin drawer face.
The pull is cast in zinc and finished in Polished Nickel, a high-sheen silver-tone surface that reflects light evenly across the bar. Polished Nickel reads warmer than chrome in most lighting conditions, which gives it some flexibility across kitchen and bath environments where the fixtures already run in a silver family. The narrow 3/8 inch bar keeps the grip compact and the silhouette clean, so the hardware contributes to the overall composition without competing with the door or drawer face beneath it.
This pull works well in transitional kitchens and baths where the cabinetry sits somewhere between a fully traditional and a strictly contemporary program. The slender bar form reads quietly against a shaker or raised-panel door, and the Polished Nickel finish coordinates naturally with chrome or nickel faucets, light fixtures, and appliance trim already in the room. Designers assembling a full hardware program can draw knobs and pulls from across the Erika collection in this finish, mixing the two forms on doors and drawers without stepping outside a single design language.
Measure from the center of one hole to the center of the other. If that distance is 3 inches (76 mm), this pull mounts without any re-drilling.
They are similar in tone but not identical. Polished Nickel tends to read slightly warmer than chrome under most lighting, so the two are close but will not be a perfect match on the same installation.
Yes. The 3 inch center-to-center spacing is common on cabinet doors and on narrower drawer fronts, so this pull suits either application where the hole pattern matches.
The Erika collection includes companion pieces in the same design language and finish, so you can coordinate knobs on doors with pulls on drawers within one series.
When the hardware program calls for a slender Polished Nickel pull on 3 inch centers, this Erika pull delivers a clean, proportionate fit without overscaling the door or drawer face it lands on.
Sold In: 1 Each