Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Erika pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 3-3/4 inch (96 mm) centers — one of the most common hole spacings in residential cabinetry.
The 3-3/4 inch center-to-center spacing is the point where a pull becomes a practical choice across nearly every cabinet in the room. Upper doors, base drawers, and vanity fronts all commonly come drilled to this spacing from the factory, which means this pull can replace existing hardware without touching a drill. For a kitchen refresh, a bath remodel, or a rental update where matching the existing hole pattern matters, starting with the right center-to-center is the decision that determines whether the job takes ten minutes or an afternoon. At 4-5/8 inches overall, the Erika pull is proportioned for mid-width fronts without stretching past the rail on a narrow door.
The pull is cast in zinc and finished in Brushed Nickel. The brushed surface is what separates this finish from a polished nickel: it diffuses light rather than reflecting it, so the hardware holds a consistent appearance under the mixed lighting conditions most kitchens and baths actually run — task lighting under cabinets, overhead fixtures, and daylight from a window all hitting the same surface at different times of day. Brushed Nickel sits in the silver-tone family and coordinates readily with stainless appliances and chrome fixtures without requiring an exact match. Within the Erika series, companion hardware in the same finish carries the same surface treatment, so knobs and pulls from the collection read as one program across doors and drawers.
This is a strong choice for a transitional kitchen or bath where the hardware should work with the room rather than stand out from it. Designers specifying a full kitchen find the 96 mm spacing reliable because it covers the widest range of stock cabinet configurations without custom drilling. Cabinet shops building on standard 32 mm system holes use this spacing routinely, and contractors doing a hardware swap on an existing installation appreciate a pull that drops onto the holes already there. The clean, narrow bar profile also means it reads well on both shaker-style and flat-panel doors, which is why it travels across project types as easily as it does.
Center-to-center is the distance between the two mounting holes — 3-3/4 inches (96 mm) on this pull — and it is the number you match to your existing holes or mark on a new door. Overall length is the full end-to-end size of the pull, which on this one is 4-5/8 inches. The two are not the same, and drilling to the overall length rather than the center-to-center is the most common installation mistake on a bar pull.
A brushed surface is more forgiving than a polished one. The texture breaks up the reflection so fingerprints and water marks are less visible, though any hardware near a sink will benefit from occasional wiping.
Yes. A bar pull of this profile works on both doors and drawer fronts. The 3-3/4 inch spacing is common on upper doors as well as base drawers in most standard cabinet lines.
The Erika collection from Top Knobs includes knobs and pulls in the same design and finish, so you can run knobs on doors and pulls on drawers from one coordinated series.
When the existing hole pattern is already 3-3/4 inches and the finish needs to stay neutral across a mixed-metal kitchen, this pull removes two variables from the decision and lets the installation move forward.
Sold In: 1 Each