Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Everitt pull is a contemporary cabinet pull for wide drawer fronts, tall doors, and any cabinetry where a shorter pull would look undersized against the front it mounts on.
The 7-9/16 inch center-to-center puts this pull in a range that suits wide base drawers, full-height pantry doors, and large appliance-adjacent cabinetry where a 3-3/4 or 5-1/16 inch pull would feel dwarfed by the front. At this spacing, the pull spans enough of the front to give it visual weight without overcrowding the panel. It is also a practical fit in kitchens and baths where the cabinetry runs in a consistent series and the drawer bank steps up in width as it approaches an island or a corner. Matching an existing 192 mm hole pattern is straightforward with no new drilling required.
The pull is cast in zinc and finished in Brushed Nickel, which is a fine-brushed silver tone with a muted sheen rather than a mirror surface. That texture is what makes brushed nickel practical in a working kitchen: it does not collect highlight glare under cabinet lighting, and everyday handling does not change how it reads across the room. Against white, gray, or wood-toned cabinetry, the finish sits as a neutral that neither competes with the fronts nor disappears into them. The 1/2 inch bar width keeps the profile slim, so the pull reads as a line rather than as a mass on the door face.
This is the pull for a kitchen, bath, or built-in where the cabinetry runs wide and the hardware needs to scale with it. Designers specifying a contemporary kitchen with slab or flat-panel fronts will find that the slim bar profile stays in the same geometric register as the doors without introducing a competing shape. Cabinet shops outfitting a full kitchen run can pair this with the Everitt knobs on narrower doors to keep the collection consistent. Homeowners replacing hardware on a wide drawer bank drilled to 192 mm centers can swap in this pull directly.
Center-to-center is the distance between the two mounting holes, 7-9/16 inches (192 mm), and that is the number that must match your existing holes or your drilling template. Overall length is 8-1/4 inches (210 mm) and describes how long the pull looks on the door, not where the holes go.
No. Brushed Nickel has a fine-grained matte texture rather than a mirror polish, which gives it a softer, more even appearance under direct light.
Yes. The Everitt collection includes companion knobs and pulls in the same design language and finish, so mixing knobs on doors with this pull on drawers works within the series.
The projection is 1-1/4 inches (32 mm) from the face of the front to the back of the grip.
When the fronts are wide and the existing holes are drilled to 192 mm centers, this Everitt pull in Brushed Nickel gives the drawer or door a proportional, contemporary handle without changing what is already there.
Sold In: 1 Each