Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Whittier pull is a contemporary cabinet pull for drawer fronts and door faces, mounted on 5-1/16 inch (128 mm) centers and finished in Polished Chrome.
The 5-1/16 inch center-to-center spacing lands this pull squarely in the range that suits mid-width base drawers, most upper cabinet doors, and the drawer stacks flanking a range or a sink. It is a spacing broad enough to give a confident grip on a heavier door while staying proportional on a standard 18- to 24-inch drawer front. For a kitchen with a mix of door and drawer hardware, this pull handles the doors and deeper drawers while its Whittier series companions cover the narrower pulls in the same design language.
The pull is cast in zinc and finished in Polished Chrome. Chrome is the neutralizing finish in a kitchen: it reads alongside stainless appliances, faucets, and light fixtures without competing with any of them. On a narrow bar the polish runs as a clean bright line along the face, which reinforces the linear geometry of flat-panel and contemporary cabinetry rather than adding a separate material note. The slim 7/16 inch bar width keeps the profile light even at this center-to-center spacing.
This pull suits a contemporary or transitional kitchen, bath, or built-in where the existing fixtures are already running chrome or polished stainless. It is a practical choice for a renovation that is matching or replacing existing hardware drilled to 128 mm centers, since it drops onto that hole pattern without modification. Cabinet shops and designers specifying new construction can pair it with the Whittier knobs on single-door uppers and run pulls at this spacing across the drawer banks, keeping the same series and finish throughout the program.
The 5-1/16 inch (128 mm) spacing is the metric-standard 128 mm hole pattern, which is a fraction wider than a nominal 5 inch (127 mm) spacing. On most installations the difference is negligible, but always measure between the centers of your existing holes before ordering a replacement.
The 1-1/8 inch projection brings the grip far enough off the door face for a full-finger hold. The narrow bar profile is a styling choice, not a grip limitation.
A polished surface will show marks more readily than a brushed or matte finish, and it wipes clean just as readily.
Yes. The Whittier collection includes matching knobs and pulls in the same design language and finish, so knobs on doors and pulls on drawers can be drawn from one series.
Choose this pull when the project calls for a 128 mm center-to-center spacing, a slim contemporary profile, and a polished finish that ties into the chrome fixtures already in the room.
Sold In: 1 Each