Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Dakota pull is a traditional bar pull for cabinet doors and drawer fronts, mounting on 6-5/16 inch (160 mm) centers.
The 6-5/16 inch center-to-center is a step up from the common 128 mm and 96 mm spacings, and that gap matters on certain fronts. A wide base drawer, a full-height pantry door, or a deep pot-and-pan drawer front is proportionally better served by a pull that spans more of its width. At this spacing the pull covers 8 inches end to end, so it sits with visual authority on a 24 or 30 inch wide front without leaving too much dead space on either side. For a cabinet shop or contractor fitting out a kitchen with a range of drawer sizes, this is the pull for the wider runs where a 128 mm bar would look undersized.
The pull is cast in zinc and finished in Brushed Satin Nickel. Brushed Satin Nickel sits in the middle of the nickel family: warmer and less stark than Polished Chrome, softer and more neutral than Antique Nickel. The brushed texture keeps the surface from picking up strong reflections under kitchen or bath lighting, which means it reads consistently across different light conditions rather than changing character as the light shifts. On painted white or light gray fronts it provides quiet contrast; on natural wood it reads as clean and contemporary without pulling toward either warm or cool.
Cabinet shops running a full kitchen in the Dakota series will use this spacing on the wide drawer banks and tall doors while stepping down to a shorter pull for narrow drawers, keeping the hardware in one collection throughout. Designers specifying traditional or transitional kitchens reach for this center-to-center when the door and drawer schedule includes several large fronts that need pull weight to match. Contractors replacing hardware on an existing layout drilled to 160 mm centers can drop this pull onto the existing holes without drilling. The Dakota series is broad enough to cover those companion pieces in the same finish, so the coordination work is already done.
Yes. 6-5/16 inches converts to 160 mm, and both values refer to the distance between the centers of the two mounting holes.
The hole spacing is wider by about an inch and a quarter, the overall length steps up from roughly 6-1/2 inches to 8 inches, and the pull reads proportionally larger on the front. The finish, bar profile, and collection are the same.
Finish names vary between manufacturers, so a Brushed Satin Nickel from one brand is not guaranteed to match another brand's same-named finish. For a consistent look, stay within the Dakota collection for companion pieces.
Yes. A bar pull works on both doors and drawers. The 160 mm spacing suits tall or wide doors as well as wide drawer fronts.
When the drawer bank or door schedule calls for a pull that holds its proportion on larger fronts, this Dakota pull at 160 mm centers delivers the span and the finish to do it.
Sold In: 1 Each