EPCO oak pull 96mm center to center gives cabinetry a wood handle sized for common 96 mm drill spacing, so existing 3-3/4 inch center to center layouts can be matched without altering hole locations across doors or drawers. The overall length of 4-1/2 inches provides extra grip area beyond the mounting holes, which helps when opening heavier fronts or wider drawers. A projection of 13/16 inch sets the hand clear of the door surface, reducing knuckle contact when pulling at an angle. The width of 2-3/16 inches spreads the pull visually and physically on the face, which helps balance narrow and mid-width fronts. Oak construction aligns this pull with wood cabinetry projects where a natural material is preferred for finish matching or later finishing steps.
The surface mount - no insert design means the pull seats directly on the cabinet or drawer face, which uses straightforward through-bore holes for fastening. Center to center: 96 mm defines the exact drilling distance between mounting holes, so boring patterns can be set once on jigs and applied repeatedly. Individually polybagged with (2) #8-32 x 1 inch screws gives the thread size and length for installation, so boring and material thickness choices can be planned around standard #8-32 machine thread use in common cabinet stock.
This EPCO Wire Series 3-3/4 inch (96 mm) center to center oak pull, WP28, fits cabinet and drawer fronts drilled on the 96 mm pattern, which is widely used in decorative hardware and moldings layouts. The 4-1/2 inch overall length lets this handle sit comfortably on medium-size cabinet doors where a compact, wood-based pull is preferred. A projection of 13/16 inch supports everyday gripping on kitchen, bath, or shop cabinetry by setting the hand slightly off the surface for clearance. The 2-3/16 inch width works across a range of stile and rail sizes, so one pull style can carry through multiple cabinet sections without changing proportions.
The defined center to center: 96 mm drilling spec allows installers to rely on fixed jigs or line-boring setups, which keeps hole placement uniform across banks of cabinets. Using #8-32 x 1 inch screws standardizes fastening hardware, so threading is predictable when working through typical door and drawer front thicknesses in woodworking projects. The surface mount - no insert configuration focuses all fitting on the face, which removes the need for hidden cups or inserts and keeps boring limited to straight through-holes. With projection at 13/16 inch and width at 2-3/16 inch, the geometry of the pull stays consistent from piece to piece, which simplifies alignment and visual layout during final hardware installation.
The EPCO WP28 pull uses a 96 mm center to center drilling pattern, which sets the mounting holes for consistent spacing on cabinet and drawer fronts.
The EPCO Wire Series WP28 pull has an overall length of 4-1/2 inches, giving more handle length than the 96 mm center spacing for added grip area.
The oak pull has a projection of 13/16 inch, positioning the handle off the cabinet face to create finger clearance during normal opening and closing.
The EPCO WP28 oak pull has a width of 2-3/16 inches, spreading its front profile across more of the stile or drawer face for visual balance.
The EPCO WP28 is a surface mount - no insert pull, so it fastens directly to the cabinet or drawer front using through-bored mounting holes.
The EPCO WP28 pull is specified with #8-32 x 1 inch screws, which match common cabinet through-bore installations using machine-thread fasteners.
The EPCO Wire Series 3-3/4 inch (96 mm) center to center oak pull WP28 provides a defined 96 mm drilling pattern, 4-1/2 inch overall length, 13/16 inch projection, and 2-3/16 inch width, so cabinet hardware on your project can follow a repeatable layout using one consistent oak handle style.
Sold In: 1 Each