Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Kent Design 116 1/4 P panel is a decorative metal grille for cabinet door frames, furniture inserts, and architectural openings where a Flat Black face is the finish direction.
The 1 inch by 1/4 inch mesh is an elongated rectangular opening, four times wider than it is tall. That proportion makes the panel read as a stack of horizontal lines rather than an even grid. Rotate it ninety degrees and it becomes vertical lines instead, so orientation is a real design choice with this pattern. Flat Black makes that effect sharper than a warm or antiqued finish would: there is no highlight on the wire surface to soften the lines, just a consistent matte tone that lets the pattern itself do the work. In a dark or high-contrast room the panel can nearly disappear into the surround; against a lighter cabinet face it draws the eye directly to the opening.
Square wire has flats rather than a curved crown, which changes how the wire reads under light. A round wire picks up a specular highlight along its length; a square section sits flat and absorbs more of the light that hits it. Paired with a matte Flat Black finish, the result is a panel with almost no reflective character, which suits contemporary, industrial, and matte-finish cabinetry where any glint in the insert would work against the room. The .063 inch wire dimension is on the lighter side of this pattern range, keeping the openings visually dominant over the wire.
This panel is a natural fit for any opening that calls for a dark, graphic face: black or dark-painted cabinetry, media enclosures, built-in storage with metal accents, and modern furniture pieces where the hardware finish is consistently matte or black. The 36 by 48 inch sheet is a wide format, practical when multiple similarly sized openings are being cut from one panel or when the insert opening itself is large. The directional mesh also suits speaker and equipment enclosures where an open patterned face is wanted without any warm-toned metallic character in the finish.
It does. The openings are 1 inch wide and 1/4 inch tall, so the panel reads as horizontal lines across the face. Turned ninety degrees, those become vertical lines. Either works, but the two read differently, so consider the opening proportion before cutting.
Flat Black is a matte, non-reflective surface. It does not carry the sheen of a lacquered or satin black, which keeps the wire from catching light and suits rooms and cabinetry built around a matte finish palette.
A woven or welded wire grille presents the same pattern from both sides, though the finish appearance may vary slightly depending on the viewing angle and light source.
36 inches wide by 48 inches long.
Choose this panel when the opening calls for a directional, non-reflective face that holds its character in dark or high-contrast cabinetry.
Sold In: 1 Each