Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the right-hand cabinet profile for Blum's TANDEMBOX drawer system, 550mm nominal length, finished in zinc and equipped with integrated BLUMOTION soft-close. It mounts to the cabinet box and carries the drawer through its full travel, closing silently under load. Order this profile alongside the matching left-hand cabinet profile and both drawer members to complete one working drawer.
In a TANDEMBOX installation, the cabinet profile is the runner that stays fixed to the cabinet side wall. The drawer member attaches to the drawer box and engages this profile when the box is set in place. Because the soft-close damper lives in the cabinet profile, the closing behavior is consistent regardless of drawer weight — a useful quality in a kitchen where drawer loads vary from a light cutlery box to a heavily stocked pot drawer. Full extension means every inch of the 550mm drawer depth is reachable when the drawer is open, which matters most in deep lower cabinets where things get lost at the back.
Zinc plating on steel is an industrial standard for corrosion resistance in dry indoor environments and gives the runner a clean metallic look that disappears behind drawer fronts and sides. Within the TANDEMBOX program, zinc-plated runners pair with zinc-plated side profiles and back connectors, so the assembled drawer reads as one coherent interior. If your project specifies a different TANDEMBOX finish — white, silver, or nickel-silver — choose the cabinet profile in that finish instead, as components across finishes are not intended to be mixed.
Cabinet shops running TANDEMBOX as their standard drawer system order cabinet profiles by nominal length and finish to match their current production spec. This 550mm zinc profile suits a 22-inch-depth cabinet run — a common depth for base cabinet drawer banks. Designers specifying handle-less kitchens or furniture with concealed hardware choose TANDEMBOX for its slim profile and the BLUMOTION close, and they often source cabinet and drawer members separately to match an existing interior finish. Homeowners replacing a failed runner in an existing TANDEMBOX installation will need to confirm the nominal length, orientation, and finish before ordering — this is the right-hand member only.
No. This is the right-hand cabinet profile only. A complete runner set for one drawer requires the left-hand cabinet profile and both drawer members (left and right). Order all four components in the same 550mm nominal length.
No. BLUMOTION is Blum's soft-close damping technology. Push-to-open in the TANDEMBOX system requires a separate TIP-ON or TIP-ON BLUMOTION unit; it is not built into this cabinet profile.
TANDEMBOX cabinet profiles mount to the cabinet side wall on the 32mm grid. In face-frame construction, rear mounting brackets or face-frame-specific installation hardware are typically needed. Check Blum's installation guide for the face-frame fitting method before ordering.
Blum designs TANDEMBOX components to be matched by finish within a drawer. Mixing zinc runners with white side profiles is not an intended pairing; choose components in the same finish for a system that fits and looks as intended.
TANDEMBOX is a metal drawer system — the side profiles are the structural sides of the drawer box. Wood drawer sides are not used with TANDEMBOX runners. Build the drawer box to Blum's published TANDEMBOX cutting dimensions for the 550mm nominal length.
A zinc-plated right-hand cabinet profile in 550mm nominal length with integrated BLUMOTION closes the gap between a component list and a finished, quietly operating TANDEMBOX drawer — as long as the left-hand profile and both drawer members are on the same order.
Sold In: 1 Each