Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Coddington pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers.
The 5-1/16 inch center-to-center spacing is the standard mid-size pattern, and it covers a wide range of cabinet situations: drawer fronts from about 12 inches wide through the mid-range, upper cabinet doors, and bath vanity drawers. At 6-15/16 inches overall, the pull reads as a full-size bar without stretching past the drawer stile, which is a balance that works on single-drawer bases and stacked drawer banks in equal measure. If you are replacing existing hardware, confirming 128 mm between your hole centers is the one step that makes this a no-drill swap.
The pull is cast in zinc and finished in Flat Black. Unlike a matte black with slight texture or a satin with warm undertones, Flat Black sits dead-even under light: no hot spots, no color shift, no highlight running down the bar. That consistency is what makes it work with both painted and wood-tone cabinet fronts. The slim 1/2 inch bar section keeps the footprint small on the door face, so the finish is what registers, not the mass of the hardware.
This pull is the right fit for a transitional kitchen or bath where the hardware needs to anchor the room without competing with the cabinetry. Designers specifying a full kitchen will find the Coddington collection's span of sizes and companion knobs useful for mixing knobs on doors and pulls on drawers within one design language. Cabinet shops and contractors running a standard 128 mm boring pattern can source this pull across a job without custom drilling. Homeowners replacing dated hardware on a mid-size drawer bank get a clean black bar that drops onto existing holes.
The pull measures 6-15/16 inches from end to end, but the two mounting holes are spaced 5-1/16 inches apart, measured center to center. The hole spacing is what you match to existing cabinetry; the overall length tells you how far the pull extends on the door face.
Flat Black is a very low-sheen finish with essentially no gloss. It reads as an even, uniform black across the bar rather than reflecting light along its length.
Yes. The Coddington collection includes companion knobs in the same series and finish, which is the practical way to run pulls on drawers and knobs on doors within one design program.
The transitional bar profile and slim cross-section suit both flat-panel and shaker fronts. The straight bar reads cleanly against the shaker rail without competing with the profile detail.
Choose this pull when the 128 mm hole pattern is already in the plan and the finish needs to hold contrast without calling attention to itself.
Sold In: 1 Each