Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Studio 917 Artisan pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 4-inch (102 mm) centers in Brushed Black Nickel.
The 4-inch center-to-center is a workhorse measurement in residential cabinetry. It appears on upper door stiles, narrow drawer fronts, and bathroom vanity doors where a shorter pull keeps the hardware in proportion to the front. For a designer or cabinet shop specifying a full run of hardware, this spacing drops onto a wide range of existing hole patterns without any new drilling, which matters most on a replacement or refit job. On new construction it is a natural choice for smaller doors and drawer fronts where a longer pull would look oversized.
The pull is cast in zinc and finished in Brushed Black Nickel. The brushed surface takes a silvery-black tone that sits between a true matte black and a polished nickel: darker than chrome, lighter than flat black, and with enough texture to keep fingerprints from reading under kitchen lighting. That quality makes it practical in high-touch locations. The 1/2-inch bar section is narrow enough to read as a fine line against the cabinet face rather than as a piece of hardware competing with the door design.
This pull is a direct choice for contemporary and transitional kitchens, baths, and built-ins where the hardware finish runs in the black-nickel or dark-silver family. Cabinet shops completing a full kitchen can mix this pull on smaller doors and shorter drawers with a longer Artisan pull at the same center-to-center spacing on wider fronts, keeping the collection consistent across the room. Homeowners updating existing hardware benefit from the 4-inch spacing, which matches one of the most widely used factory drilling patterns in residential cabinets.
The pull measures 4-1/4 inches (108 mm) end to end. The center-to-center mounting dimension is 4 inches (102 mm), so there is approximately 1/8 inch of overhang beyond each hole on either side.
It reads as a dark, cool-toned silver rather than a true black. The brushed texture keeps the surface from reflecting sharply, giving it a soft, muted quality that works alongside both black and chrome fixtures.
Yes. A bar pull mounts the same way on a door stile as on a drawer front. The 4-inch spacing and 4-1/4-inch overall length are proportioned for narrower fronts, so it suits upper doors and single-door base cabinets as naturally as it does shorter drawers.
The Artisan series includes coordinating hardware. Check sibling SKUs in the same series and finish for knobs and pulls in other center-to-center sizes.
When the hole pattern is 4 inches and the finish program calls for something darker than chrome, this pull covers both requirements without asking you to adapt around it.
Sold In: 1 Each