Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Studio 917 Capital pull is a contemporary bar pull for cabinet doors and drawer fronts, built around an 11-5/16 inch (287 mm) center-to-center spacing that suits wide drawer banks, pantry fronts, and full-height cabinet doors where smaller hardware would look undersized.
At 11-5/16 inches between mounting holes, this pull is sized for cabinetry that shorter pulls leave looking underdressed. Wide pot drawers, large-format drawer banks, pantry door fronts, and tall wall cabinet doors are the natural fits. On those surfaces, a pull at this center-to-center spans enough of the front to stay visually proportional rather than floating at the center of a wide blank face. The 11-5/8 inch overall length extends just slightly beyond the hole spacing, keeping the ends clean without overhanging the front.
The pull is cast in zinc and finished in Matte Black. The matte surface holds a consistent tone under kitchen and bath lighting rather than picking up hot spots the way a polished finish does. On light-colored fronts, the matte black reads as a deliberate contrast element. On dark fronts it becomes part of a tonal composition, letting the door material carry the room. The 3/4 inch squared bar section keeps the profile flat and linear, sitting close to the face of the front and staying in the same geometric register as a slab or shaker door.
This pull suits designers and cabinet shops specifying hardware for contemporary kitchens, baths, and built-ins where the program runs black and the cabinetry includes at least some wide drawers or full-height doors that call for hardware at this scale. It also fits remodel projects replacing existing hardware on cabinets already drilled to this spacing. Because it is part of the Capital collection, companion pieces in the same series carry the same design language and finish, making it straightforward to run matching knobs on doors and pulls on drawers without mixing visual families.
Center-to-center is the distance between the two mounting holes, which is the number to match to your existing holes or your drilling template. Overall length is the end-to-end size of the pull, which is always a bit larger. On this pull, center-to-center is 11-5/16 inches and overall length is 11-5/8 inches.
Yes. A pantry door or a tall full-height cabinet front is one of the natural applications for a pull at this center-to-center. The scale suits a larger front much better than a shorter pull would.
Matte finishes do not show fingerprints and smudges as readily as polished surfaces do, and they wipe down easily with a damp cloth.
Yes. The Capital series from Studio 917 includes additional hardware in the same design and finish, so you can coordinate across different door and drawer sizes within one kitchen or bath.
When a wide drawer or a full-height door calls for hardware that actually spans it, this pull at 11-5/16 inches on center delivers the proportion and the matte black finish to carry a contemporary hardware program at the right scale.
Sold In: 1 Each