Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Studio 917 Cascade pull is a contemporary tab-form cabinet pull that mounts on 1-1/4 inch (32 mm) centers, the tightest spacing in the Cascade family and the right fit for narrow drawers, small door fronts, and any application where a larger center-to-center simply will not land on a practical hole pattern.
Most cabinet pulls are drilled at 96 mm or wider, but not every front in a kitchen or bath is that wide. Spice drawer banks, narrow rollout trays, small inset doors, furniture-scale pulls on nightstands and dressers, and shallow upper cabinet doors all call for a tighter hole pattern. At 32 mm center-to-center, this pull fits fronts where a larger pull would either crowd the edges or require new holes that do not exist. It is also the right choice when existing holes are already drilled at this spacing and the goal is a direct swap rather than a refit.
The pull is cast in zinc and finished in Matte Black. The tab form is slender at 3/16 inch wide, so the Matte Black surface reads as a thin, even line across the face of the front rather than as a visual mass. A matte surface avoids the reflective variation a polished finish would introduce in the same narrow profile, keeping the hardware consistent under changing kitchen or bathroom light. Against light cabinetry it holds a graphic contrast; against dark fronts it recedes into the face almost entirely.
This pull suits designers and cabinet makers working on projects where the drawer or door layout includes fronts too narrow to accept a standard 96 mm pull without the hardware looking oversized or landing awkwardly close to the edges. It also suits homeowners replacing existing hardware drilled at this spacing who want a clean contemporary update without taking on a redrilling job. The Cascade collection runs across multiple center-to-center sizes, so specifying the full run of drawer and door fronts in one kitchen under a single series and finish is straightforward.
On a tab pull this compact, the grip stands off the door face nearly as much as the pull spans end to end. The 1-3/4 inch projection means there is enough clearance behind the grip for a fingertip even though the overall footprint stays small.
A 32 mm center-to-center is well suited to narrow fronts where a longer pull would crowd the edges. Confirm the hole spacing matches before ordering if you are replacing existing hardware.
The Cascade collection is available in multiple center-to-center sizes in the same Matte Black finish, so you can run the 32 mm pull on narrow fronts and step up to a wider spacing on larger drawers while keeping the same design language throughout.
The finish is applied over a zinc substrate. It is a low-sheen matte surface rather than a gloss or polished coating.
When the hole pattern calls for 32 mm and the finish program calls for Matte Black, this pull closes the gap without compromise on either dimension.
Sold In: 1 Each