Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Studio 917 Cascade pull is a contemporary tab pull for cabinet doors and drawer fronts where a 2-3/16 inch (56 mm) center-to-center spacing is required. Its slim profile keeps it proportional on narrow fronts while still offering a confident grip clearance.
The 2-3/16 inch center-to-center spacing targets the narrower end of the cabinet hardware spectrum. That puts this pull at home on spice drawer fronts, slim upper-cabinet doors, vanity drawers, and any front where a 3-3/4 inch or wider pull would visually overpower the piece. It also makes it the right fit when existing holes were drilled at this spacing and the goal is a clean swap without picking up a drill. The 3 inch overall length keeps it proportional: the pull does not run edge to edge on a narrow front, which gives it room to read as hardware rather than as a bracket.
The pull is cast in zinc and finished in Matte Black. On a tab form this narrow, a flat low-sheen black reads as a clean line against the door face rather than as a feature, which suits slab and shaker fronts equally. Matte Black absorbs kitchen light instead of reflecting it, so the pull does not compete visually with the cabinetry on either a light or a dark finish. The zinc base gives the pull consistent weight in the hand without the cost of a solid-metal part.
This pull is a natural choice for a contemporary kitchen or bath where black is already in the hardware program and the cabinetry includes at least some narrower drawers or doors that need a properly scaled fitting. Designers running a mixed-size pull program across a kitchen will find the 56 mm spacing useful for the fillers and spice pulls that step down from the wider bar pulls on full-depth drawers. Because it belongs to the Cascade collection, companion pieces in the same series carry the same design language and finish, making it straightforward to build a consistent hardware program across door knobs and larger drawer pulls.
The tab form is a flat projecting plate gripped with the fingertips, typically narrower in cross-section than a bar pull. This one measures 3/16 inch wide, so it presents as a thin horizontal line on the door face rather than a cylindrical bar.
The projection is 1-3/4 inches, measured from the face of the door front to the back of the grip.
Yes. The Cascade series from Studio 917 includes companion pieces in matching finishes, so you can pair this pull with knobs or larger pulls from the same collection for a consistent look.
Matte Black is a standard applied finish over zinc. It is suited to normal indoor cabinetry use. This pull is for interior applications.
When the front is small and the hole spacing is 56 mm, this pull lands where it should: proportional, flat, and in a finish that holds its own without drawing attention away from the cabinetry.
Sold In: 1 Each