Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Studio 917 Cornerstone bar pull mounts on 6-5/16 inch (160 mm) centers, a spacing that suits wide base drawers, full-height pantry doors, and cabinet fronts where a shorter pull would look undersized.
The 160 mm center-to-center is the step up from the 128 mm pulls commonly used on mid-width drawers, and it covers the range where cabinetry starts to feel wide: a 30 to 36 inch base drawer, a tall upper cabinet door, a pantry pull, or a two-door wall cabinet where one pull on each door looks too small. At 8-5/8 inches overall, the pull has enough length to anchor a large front without looking stretched. It also reads as a deliberate design choice rather than the default, which matters in kitchens where hardware is a finishing detail rather than an afterthought.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface cuts the reflectivity of the nickel tone, so the pull holds its color evenly under kitchen and bath lighting rather than throwing bright spots. Satin Nickel is one of the most broadly coordinating finishes in the silver-tone family: it sits comfortably alongside stainless appliances, chrome fixtures, and other brushed metals without requiring an exact match. The slim 1/2 inch bar keeps the profile flat and linear, which suits both slab and shaker fronts without competing with the door style.
Cabinet shops and designers specifying a full contemporary kitchen will find this spacing particularly useful at the wide end of the base cabinet run, where a 96 mm or 128 mm pull would disappear on a 30 or 36 inch front. Homeowners replacing hardware on existing wide drawers drilled to 160 mm centers can drop this pull onto the existing holes. It also works on vanity drawers wider than 24 inches, on furniture pieces with broad drawer fronts, and on any application where the hardware should scale with the front rather than contrast it. Because it is part of the Cornerstone series, companion pieces in the same design language and finish are available for doors that need a knob instead of a pull.
Yes, if your existing holes are drilled at 6-5/16 inch (160 mm) centers. Measure between the centers of both holes before ordering to confirm.
The warm undertone of satin nickel is close enough to stainless that the two read as the same metal family in most kitchens. It is not an exact match, but the brushed texture keeps the difference from being distracting.
The bar is 1/2 inch wide with a flat face, not a round cross-section. It sits flush to the profile rather than bowing outward.
A surface-mounted bar pull of this length works on both. On a door it typically mounts vertically; on a drawer it mounts horizontally. The 160 mm spacing and 8-5/8 inch length suit wide fronts in either orientation.
When the front is wide enough that a shorter pull looks like an accessory rather than a statement, this 160 mm Cornerstone bar pull in Brushed Satin Nickel is sized to match.
Sold In: 1 Each