Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Studio 917 Cornerstone bar pull is a contemporary cabinet pull built for doors and drawer fronts where a shorter pull would get lost in the width of the front.
At 6-5/16 inches center-to-center, this pull is sized for the wide drawer banks, pot-and-pan drawers, sink base doors, and tall upper cabinet fronts where a 3-3/4 inch or 5-1/16 inch pull would look undersized. Wide fronts need hardware that spans enough of the face to feel intentional, and the 8-5/8 inch overall length of the Cornerstone does that without becoming the dominant visual element in the room. It also drops directly onto any cabinet drilled to 160 mm centers, which is a spacing found throughout frameless European-style cabinetry and increasingly in domestic face-frame construction.
The pull is cast in zinc and finished in Matte Black. Matte Black is a flat, non-reflective surface that stays even under task lighting rather than picking up hot spots the way a polished finish does. On a wide bar pull, that matters: a long polished surface can draw more attention than intended, while a matte surface holds its place in the room. The 1/2 inch bar width keeps the cross-section slim, so the pull reads as a horizontal line on the front rather than as a structural element. Against white, gray, or natural-wood cabinet fronts, matte black delivers clear contrast; against charcoal or black cabinetry, it recedes cleanly.
This pull suits cabinet shops, designers, and homeowners specifying hardware for a contemporary kitchen or bath where the drawer and door fronts are wide enough to warrant a 160 mm pull. It is a practical choice for a pot-and-pan drawer, a wide base cabinet with two doors, or an appliance-panel row where consistent spacing across the run matters. Because it is part of the Cornerstone collection, companion pieces in the same series and finish are available for doors and smaller drawers, so the hardware program can stay consistent across the whole project without mixing design languages.
Measure between the centers of your two existing mounting holes. If that distance is 6-5/16 inches (160 mm), this pull is a direct replacement with no new drilling required.
The bar is 1/2 inch wide with a narrow profile. It is a straight bar pull, not a tubular or D-handle form.
A matte finish shows fewer fingerprints than a polished surface and wipes clean easily. It is a practical choice for high-traffic drawers.
The Cornerstone collection includes companion hardware in the same series, so knobs and pulls share a consistent design language and finish within the line.
Choose this pull when the cabinet front is wide enough to call for 160 mm centers and the hardware program calls for a clean matte black line across the face of the drawer.
Sold In: 1 Each