Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Studio 917 Cornerstone pull is a contemporary bar pull for cabinet doors and wide drawer fronts, mounting on 8-13/16 inch (224 mm) centers.
At 8-13/16 inches (224 mm) center-to-center, this pull is built for the wider runs of a kitchen or built-in: a 30- or 36-inch base drawer, a wide pantry door, a bank of deep drawers on an island, or a furniture-scale cabinet face. That spacing is also common on appliance-height panels where the manufacturer has drilled on 224 mm centers, making this a direct replacement without new holes. The 11-3/16 inch overall length spans the front in proportion to its width, which is why pull sizing at this scale reads as intentional rather than as an afterthought.
The pull is cast in zinc and finished in Matte Black. A matte surface scatters light evenly rather than concentrating it into a highlight, so the pull reads as a flat plane of black against the cabinet front rather than as a reflective bar. On light-colored cabinetry the contrast is sharp and graphic. On dark fronts the pull recedes into the same tone and the hardware almost disappears, leaving the form of the cabinetry to do the work. Zinc construction gives the part a solid feel at this length, keeping the bar from flexing when gripped at its center.
This pull suits contemporary and transitional kitchens, media built-ins, and laundry or mudroom cabinetry where at least some of the fronts are wide enough to justify a pull at this spacing. Cabinet shops and designers running a mixed hardware program will find it coordinates naturally with smaller Cornerstone pulls and knobs in the same series, so the same matte black language carries across doors and drawers regardless of width. For a contractor sourcing a volume install, the consistent finish and profile make it easy to maintain a single hardware standard across a project.
The two mounting holes are 8-13/16 inches (224 mm) apart, measured center to center. The pull is 11-3/16 inches end to end, so allow clearance beyond the holes on both sides.
Yes. If the existing holes are on 224 mm (8-13/16 inch) centers, this pull drops on without new drilling.
Squared, at a 1/2 inch section, so the face sits flat rather than curving outward from the door.
The Cornerstone collection spans multiple center-to-center sizes in Matte Black, so companion pieces in the same series share the same profile and finish across a full cabinet run.
When the drawer or door front is wide enough to need hardware that fills the space rather than floats in it, this pull gives the Cornerstone collection's clean matte bar at the spacing those fronts require.
Sold In: 1 Each