Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Studio 917 Heritage cup pull is a traditional shell-form drawer pull sized to mount on 3 inch (76 mm) centers, a compact spacing well suited to smaller drawers and spice banks where a wider pull would overwhelm the front.
A cup pull is a drawer fitting. The hand comes in from below, hooking into the shell in a motion that is natural on a drawer and awkward on a door. On a narrow front — a spice drawer, a small utility bank, a vanity with stacked drawers — the 3 inch hole spacing is the right fit where a 3-3/4 inch or wider pull would run too close to the edges of the front or look outsized against it. The traditional pairing in a Heritage kitchen is cup pulls on drawers and companion knobs from the same series on doors, giving the room a cohesive set of hardware without mixing collections.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface scatters light rather than reflecting it in a single bright point, which keeps the finish from competing with polished fixtures nearby. Satin Nickel reads as a cool, neutral silver that coordinates readily with stainless appliances and chrome plumbing, making it a reliable choice for a kitchen where the hardware needs to work alongside multiple metals. The cup shell itself is wide enough at 1-5/8 inches (41 mm) to feel substantial in the hand without adding visual bulk to the front.
This pull is a natural fit for a traditional or transitional kitchen where the narrow drawers need hardware that is proportional rather than bold. Cabinet shops fitting out a spice-drawer bank, a painted inset kitchen, or a butler's pantry with stacked shallow drawers will find the 3 inch spacing drops cleanly onto the most compact standard hole pattern. Designers specifying a full Heritage hardware program can run this pull alongside the wider cup pulls in the same series on larger drawers, keeping the shell form consistent across every front while matching the hole spacing to the front width.
Center-to-center is the distance between the two mounting holes — 3 inches (76 mm) here — and that is the number to match to your existing holes or your drilling layout. Overall length is the outside measurement of the pull from end to end, which is 3-7/8 inches (98 mm) on this model.
Yes. A cup pull has an up and a down. The open shell should face down so the hand comes in from below. Mounted the other way, the cup faces upward and collects debris.
Finish names are not standardized across manufacturers. Brushed Satin Nickel is Studio 917's own finish for this series. For a guaranteed match, stay within the Heritage collection rather than mixing brands.
The cup form is designed to be gripped from underneath, which suits a drawer naturally. It can be mounted on a door, but the grip is less intuitive in that position. Most traditional installations put cup pulls on drawers and knobs on doors.
For a narrow drawer front that calls for a traditional cup pull in a neutral silver finish, the 3 inch Heritage pull lands precisely where wider options fall short.
Sold In: 1 Each