Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Clemente pull is a transitional bar pull designed for cabinet doors and drawer fronts, mounting on 6-5/16 inch (160 mm) centers.
The 160 mm center-to-center spacing puts this pull in the range that works well on mid-width to wide drawer fronts and on the taller doors found in base cabinets and pantry configurations. At 7-1/4 inches end to end, it carries enough visual presence to anchor a wider front without overwhelming a standard-width door. The narrow 7/16 inch bar section keeps the silhouette lean even at this length, so it reads as a line across the front rather than a heavy fixture on it. Designers commonly reach for this spacing when the hardware needs to scale with the cabinetry without stepping up to a true appliance-pull proportion.
Unlike most bar pulls in this category, which are cast zinc with a plated finish, this pull is made from stainless steel. Polished Stainless Steel is a bright, mirror-adjacent finish that sits in the same tonal family as chrome but with the warmth that comes from the steel itself rather than from a plating layer. The surface reads consistently even under direct kitchen lighting, and the material underneath is the same throughout the pull rather than a substrate with a finish applied over it. This matters most in environments where the hardware sees regular handling and where a base-metal edge would eventually show through a plated surface.
This is a practical specification for a transitional kitchen where the hardware needs to coordinate with stainless appliances and a stainless sink without committing to a fully contemporary look. The Clemente bar profile is clean enough for a slab-front cabinet program and restrained enough for a shaker door, which is the precise middle ground the transitional category covers. It also suits a bathroom vanity with mid-width drawers, or a built-in where the hardware spacing was set by an earlier install and 160 mm is what the holes already are. Cabinet shops and contractors outfitting a full kitchen run will find the Clemente series covers the common center-to-center spacings, so one collection can carry the whole job.
The Material Type is stainless steel, not a zinc base with a plated surface. Polished Stainless Steel is the finish applied to that stainless base.
Polished Stainless Steel reads in the same silver tone family as most stainless appliance surfaces. Finish appearance varies between manufacturers, so the coordination will be close rather than an exact match in every case.
160 mm center-to-center is a common spacing for mid-to-wide drawers. Many designers size hardware to roughly a third of the front's width as a proportion guide, though this is a design preference rather than a fixed rule.
Yes. The Clemente collection from Top Knobs includes pulls at other center-to-center spacings and coordinating knobs in the same finish and design language.
Choose this pull when the 160 mm spacing is what the job calls for and the hardware needs to be stainless through and through, not just stainless in appearance.
Sold In: 1 Each