Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Studio 917 Heritage pull is a traditional arch-form cabinet pull for doors and drawer fronts, mounting on 3-3/4 inch (96 mm) centers in a Matte Black finish.
The 3-3/4 inch (96 mm) center-to-center dimension is the single most common drill pattern in residential kitchen and bath cabinetry. That means this pull is a direct fit on the majority of existing drawer banks without a new hole being drilled. For a renovation or a reface where the case is staying and only the hardware is changing, matching the spacing takes the guesswork out of the swap. Measure between the centers of the existing holes to confirm, then order.
The pull is cast in zinc and finished in Matte Black. The arch form gives the grip a slight crown, and the matte surface keeps the finish even under kitchen lighting rather than collecting reflections along the curve the way a polished finish would. Matte Black holds its contrast cleanly against both light-painted and natural-wood fronts, and the low sheen is forgiving on marks between cleanings. The 11/16 inch grip width and the 1-9/16 inch projection give the hand a comfortable hold without the pull reading as heavy on the door face.
This is a pull for traditional and transitional kitchens, built-ins, and furniture-style cabinetry where the hardware should carry some visual weight and a recognizable historic silhouette. The arch form suits shaker, raised-panel, and inset doors more naturally than a bar pull does, because the curve follows the geometry of the door rather than contrasting with it. It is also a practical choice for a spec kitchen or a renovation project where most of the existing hole patterns are at 96 mm: running a pull that drops onto standard spacing keeps the install moving without patching and re-drilling.
Measure from the center of one screw hole to the center of the other on your drawer or door front. If that distance is 3-3/4 inches (96 mm), this pull mounts without additional drilling.
The projection is 1-9/16 inches (40 mm) from the door face to the back of the grip, which is on the generous side for an arch pull and gives a comfortable finger-wrap behind the bar.
Yes. An arch pull works on both doors and drawer fronts, and mixing pulls on drawers with knobs on doors from the Heritage collection is a common traditional hardware program.
This page covers the Matte Black variant. The Heritage series is available in additional finishes and center-to-center sizes across the family.
Choose this pull when the cabinetry calls for a classic arch silhouette in matte black and the drawer bank is already drilled to the 96 mm pattern that most kitchen cabinetry uses.
Sold In: 1 Each