Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Studio 917 City Series pull is a contemporary bar pull for cabinet doors and drawer fronts, designed around the 3-3/4 inch (96 mm) center-to-center spacing that accounts for more of the existing cabinetry in kitchens and baths than any other single measurement.
The 3-3/4 inch center-to-center dimension is the standard drilling for the majority of stock and semi-custom cabinetry sold in North America. That means this pull drops onto existing holes in most kitchen and bath cabinet banks without any new drilling, which is the deciding factor on a refacing project, a rental refresh, or any job where the carcases stay and only the hardware changes. For new construction the same advantage applies: standard shop jigs are already set to this spacing, so installation moves at the speed of the drill jig rather than the speed of the tape measure.
The pull is cast in zinc and finished in Matte Black. The matte surface does not have a polish layer to catch and hold light, so it stays visually flat across the front of a cabinet run rather than throwing bright points wherever the overhead light hits. On white, gray, or light-wood cabinetry the contrast reads sharp and deliberate. On dark or black fronts the hardware sits in the same value range and the line of the bar becomes the detail rather than the finish.
This pull suits a contemporary kitchen, bath vanity, or built-in case where the hardware program is matte black and the fronts are flat or near-flat. It is a practical choice for cabinet shops running production kitchens who need a clean, consistently available pull that installs on standard jig spacing. It also works for a homeowner replacing a single drawer pull where the existing holes are at 96 mm and the finish target is matte black. The City Series includes companion pieces within the Studio 917 lineup, so coordinating doors and drawers with knobs and pulls in the same design language is straightforward.
Yes. This pull mounts on 3-3/4 inch (96 mm) centers, so it replaces any pull at that spacing with no new holes. Measure between the centers of your existing holes to confirm before ordering.
The bar is 9/16 inch (14 mm) wide, which is a slim squared section. It is a grip designed for a clean look rather than for maximum hand contact, and it suits fingers-only operation on a drawer or door.
A matte finish shows less of the smear and oil pattern that a polished surface picks up, though it is not immune. It is easier to wipe clean without leaving a visible buffing mark than a high-sheen finish.
The City Series is part of the Studio 917 collection, which includes coordinating hardware in the same design style and finish. Match by series and finish name when selecting companion pieces.
When the hole pattern is already 96 mm and the finish target is matte black, this pull removes the measurement step and the drilling step from the job, leaving only the install.
Sold In: 1 Each