Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Studio 917 City Series pull is a contemporary bar pull that mounts on 5-1/16 inch (128 mm) centers, a spacing suited to mid-to-wide drawer fronts and full-height cabinet doors.
The 5-1/16 inch (128 mm) center-to-center dimension is one of the most widely used pull spacings in modern cabinetry, appearing on base drawers in the 18 to 24 inch range, on pantry doors, and on upper cabinet doors where a shorter pull would look undersized. At this spacing, the pull spans enough of the front to read as intentional hardware rather than an accent piece. For a cabinet shop or contractor running an open floor plan with a mix of drawer banks and tall uppers, a single pull at 128 mm can often work across the whole run, which reduces the number of SKUs on the job.
The City Series pull is cast in zinc and finished in Matte Black. The matte surface scatters light rather than reflecting it, so the pull stays visually quiet under kitchen or bath lighting instead of drawing attention with glare. On a dark front it integrates; on a light front it holds contrast without competing with the cabinetry. The slim 1/2 inch bar section keeps the profile from reading as heavy, which makes this pull well suited to slab-front and shaker cabinetry where the hardware is meant to complete the geometry rather than interrupt it.
This pull is a practical choice for designers and cabinet shops specifying a contemporary kitchen, bath, or built-in where the hardware program is matte black and the hole pattern is already drilled at 128 mm. It also suits renovation work where existing holes are at this spacing and the goal is a clean, modern replacement. Homeowners replacing hardware across a large kitchen will find this spacing covers more front widths than a shorter pull, which can reduce the need to mix sizes across the run.
Center-to-center is the distance between the two mounting holes, which is 5-1/16 inches (128 mm). Overall length is the full end-to-end size of the pull, which is 5-11/16 inches (144 mm). Match your existing holes to the center-to-center figure, not the overall length.
The projection is 1-1/8 inches (29 mm), measured from the cabinet face to the back of the grip.
Yes. The City Series from Studio 917 includes companion pieces in the same design language and finish, so you can coordinate knobs on doors with pulls on drawers without mixing collections.
It works on both. At 128 mm centers and 5-11/16 inches overall, it is proportioned for mid-to-wide drawer fronts and for full-height upper doors.
The Studio 917 City Series pull at 128 mm centers gives a contemporary kitchen a single, consistent hardware note in matte black that holds from the narrowest drawer to the tallest door.
Sold In: 1 Each