Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Studio 917 Skyline pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers.
The 5-1/16 inch (128 mm) center-to-center spacing is the practical sweet spot for a wide range of mid-size drawer fronts and upper cabinet doors. It sits between the narrower 96 mm pulls suited to compact drawers and the longer 160 mm pulls that belong on wider fronts, which means this one handles the bulk of a typical kitchen's work. On a 15 to 18 inch drawer front it lands proportionally without overreaching, and on a standard upper door it stays well clear of the hinge side. Shops and installers who run a lot of mid-size cabinetry can standardize on this spacing and drill the whole run before hardware arrives.
The Skyline pull is cast in zinc and finished in Matte Black. The 3/8 inch squared section is narrower than the bar pulls commonly found at this center-to-center, which keeps the profile lean even when the pull spans five-plus inches. On a flat slab or shaker front, the squared face sits flush with the geometry of the door rather than introducing a curve. Matte Black is a flat, non-reflective finish that holds a consistent appearance under kitchen lighting rather than picking up hot spots. It reads as a shadow against light fronts and as a line against dark ones.
This pull is a practical choice for a contemporary kitchen or bath renovation where the hole pattern is already drilled at 128 mm and the hardware program is black. It suits designers running a matte black fixture package and wanting the cabinet hardware to stay in the same finish family without the glare of a polished surface. For a cabinet shop quoting a spec project, the 128 mm spacing covers drawer banks through most of the mid-range drawer box sizes without special drilling. Homeowners replacing existing hardware on a drilled-and-ready carcass can swap these in without touching a drill press.
The mounting holes are on 5-1/16 inch (128 mm) centers. Measure between the centers of your existing holes to confirm it matches before ordering.
The bar section is 3/8 inch (10 mm) wide, which is on the slender side for a pull of this length. It gives the Skyline a fine-line look rather than a chunky bar profile.
A matte finish shows marks less readily than a polished surface and wipes clean easily. It will not show the oil-track fingerprints that a high-gloss black would.
The Skyline series includes other center-to-center sizes in Matte Black, so you can run the same profile and finish across drawer fronts of different widths.
Choose this pull when the project calls for 128 mm centers, a squared bar in a slender section, and a flat black that stays quiet under kitchen light.
Sold In: 1 Each