Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Studio 917 Skyline pull is a contemporary bar pull designed for cabinet drawers and doors where a shorter pull would look undersized or feel inadequate to grip.
At 6-5/16 inches center-to-center, this pull is at home on fronts where a 96 mm or 128 mm pull would look like it got lost. Wide base drawers, full-height pantry doors, and large island drawer banks all benefit from hardware that spans a meaningful portion of the front. The grip reads as intentional rather than token, and the slim bar section keeps it from dominating the cabinetry the way a heavier profile would at the same length. It is also a practical size for two-handed use on a deep drawer where you want purchase on both ends of the pull at once.
The pull is cast in zinc and finished in Brushed Satin Brass. The brushed surface takes the shine off what would otherwise be a bright gold tone, landing on something warmer and more restrained than polished brass while still reading clearly as a gold-family finish. Under kitchen lighting it does not flare, which makes it easier to coordinate with other warm metals in the room such as unlacquered brass faucets or antique-tone fixtures. Zinc construction gives the pull its weight without the cost of a solid brass casting.
This is the right pull for a designer or cabinet shop building out a contemporary kitchen, bath, or built-in that needs hardware in a warm gold tone at a scale that matches wider fronts. It fits renovation projects where existing holes are drilled on 160 mm centers, and it fits new builds where the drawer bank runs wide enough to justify the spacing. The Skyline collection supports a consistent hardware program across doors and drawers, so the same design language can run through the whole installation without mixing series.
The pull is 6-5/8 inches (168 mm) end to end. The mounting holes are 6-5/16 inches (160 mm) center-to-center, so the pull extends about 3/8 inch beyond the holes on each side.
The source data does not specify a lacquer topcoat. For questions about long-term finish care, contact the supplier before ordering.
Yes. The Skyline series includes companion pieces in multiple center-to-center sizes and matching knobs, so you can run a consistent hardware program across doors and drawers.
The pull can mount on any front where the two holes can be drilled at 6-5/16 inch centers with enough material around each hole. The overall length of 6-5/8 inches should not overhang the front edge.
Choose this pull when the drawer or door is wide enough to deserve hardware that spans it properly, finished in a brushed warm brass that coordinates without competing.
Sold In: 1 Each