Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Studio 917 Skyline pull is a contemporary bar pull for cabinet doors and wide drawer fronts, mounting on 6-5/16 inch (160 mm) centers.
The 6-5/16 inch center-to-center dimension is the deciding factor for most buyers landing on this page. At that spacing, the pull physically scales to a wide base drawer, a deep pot-and-pan front, or a tall pantry door in a way that shorter pulls cannot. A 96 mm or 128 mm pull on a 24-inch drawer front can look stranded; a 160 mm pull reads as proportional because the hardware occupies enough of the front to hold the visual weight of the cabinet. This is also the spacing that replaces a lot of existing 160 mm hardware without any new drilling, making it a practical choice for a kitchen refresh where the hole pattern is already in place.
The Skyline pull is cast in zinc with a squared 3/8 inch bar section, a narrow width that makes the pull read as a line rather than a block across the face of the door. The squared geometry puts flat faces against the hand and against the eye, which is what makes it sit naturally on slab and flat-panel fronts without adding a curve the cabinetry does not have. The Brushed Satin Nickel finish is a warm mid-tone silver with a brushed texture that reduces glare and diffuses light evenly across the bar. It does not pick up directional highlights the way a polished nickel would, which keeps the hardware consistent whether the kitchen light is overhead or from the side.
This pull is built for contemporary kitchens and baths where the fronts are wide, the hardware program is silver-tone, and the overall look calls for something slim and precise rather than heavy or decorative. Cabinet shops specifying an entire kitchen will find the 160 mm spacing addresses the large-format drawers in a base run while the matching Skyline pieces at narrower spacings handle the upper doors and smaller drawers. Designers assembling a mixed program of knobs on doors and pulls on drawers can pull from the same Skyline collection to keep the series unified across every front. For a direct replacement job, confirm the existing hole spacing is 6-5/16 inches center-to-center before ordering.
The pull measures 6-5/8 inches (168 mm) end to end. The 6-5/16 inch (160 mm) figure is the center-to-center hole spacing, which is always smaller than the overall length.
It reads as a neutral mid-tone silver. The brushed texture softens it compared to a polished nickel, and it sits between the cooler look of polished chrome and the warmer look of a satin brass.
Yes. The Skyline collection spans multiple center-to-center sizes in the same profile and finish, so the bar section and finish will be consistent across the pulls regardless of spacing.
The pull projects 1-1/8 inches (29 mm) from the face of the door or drawer front to the back of the bar.
When the drawer is wide enough that a shorter pull looks undersized, the 160 mm Skyline pull brings the hardware into proportion without adding visual weight the front does not need.
Sold In: 1 Each