Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Studio 917 Skyline pull is a contemporary bar pull for cabinet drawers and doors, built around a 6-5/16 inch (160 mm) center-to-center spacing that suits the wider fronts found on base cabinets, pantry doors, and furniture-scale island drawers.
The 6-5/16 inch center-to-center dimension is the step up from the 128 mm pulls common on mid-width drawers, and it is the right call when the front is wide enough that a shorter pull looks proportionally small. Wide base drawers, 30-to-36-inch sink cabinet doors, and full-height pantry fronts all benefit from hardware scaled to match. On those fronts the 160 mm spacing keeps the pull centered and fills enough of the face that it feels intentional rather than undersized. If the existing holes in the project are already drilled at 160 mm, this pull drops in without new drilling.
The pull is cast in zinc and finished in Matte Black. The 3/8 inch bar is narrow enough that the pull reads as a graphic line across the door rather than as a handle with physical presence, which is what the Skyline profile is after. Matte Black is a flat finish with no polish, so it does not pick up reflections under kitchen or bath lighting. Against white, gray, or natural wood fronts the contrast is immediate; against darker cabinetry it integrates without disappearing. The low-sheen surface also wipes cleanly without showing the smear a polished finish would leave behind.
This pull fits a contemporary kitchen, bath, or built-in project where the hardware is matte black and the cabinetry has wider-than-average fronts. Cabinet shops laying out a full kitchen will find that the 160 mm spacing covers the wider drawers in a bank while the 128 mm version handles the narrower ones, with both belonging to the same Skyline collection and finish. Designers specifying a complete black hardware program can pull matching knobs and companion pieces from the Skyline series without crossing brands or finishes. Contractors doing a kitchen replacement on a cabinet line already drilled at 160 mm can swap in this pull directly.
A 6-5/16 inch pull is commonly used on drawer fronts in the 18-to-24-inch range, where a shorter pull would look undersized. Sizing hardware to roughly a third of the drawer width is a common design convention, though it is a preference rather than a requirement.
Measure the distance between the centers of the two existing holes. If that measurement is 6-5/16 inches (160 mm), this pull mounts without new drilling.
The Skyline bar is squared in profile at 3/8 inch wide, so the face sits flat and the silhouette stays geometric rather than curved.
Yes. The Skyline collection is available in multiple center-to-center sizes in Matte Black, so you can use the 160 mm pull on wider fronts and a shorter spacing on narrower ones while keeping the same profile and finish throughout.
When the cabinetry is wide and the program is matte black, this pull covers the spacing without compromise, and the narrow Skyline bar keeps the hardware from competing with the cabinetry it is opening.
Sold In: 1 Each