Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Studio 917 Skyline pull is a contemporary arch-profile cabinet pull that mounts on 5-1/16 inch (128 mm) centers, one of the most widely used hole spacings in residential cabinetry.
The 128 mm center-to-center is the go-to spacing for mid-width cabinet drawers, a range that covers most base-cabinet drawer banks, bathroom vanity drawers, and the majority of upper cabinet doors in a standard kitchen layout. Because 128 mm is a near-universal hole pattern in factory-built cabinetry, this pull is a common choice for retrofit projects where the goal is a clean hardware swap with no new drilling. It also suits new builds specifying a pull that can carry across drawer widths and door heights without looking undersized on one front and overscaled on another.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface diffuses light across the arch rather than reflecting it as a hard line, which keeps the pull from reading as a focal point on the door. Satin Nickel is a finish that coordinates naturally with stainless appliances and chrome plumbing fixtures without requiring an exact match, making it a practical default for kitchens and baths where those metals are already present. The arch cross-section introduces a gentle curve to the grip while the overall silhouette remains geometric, placing it in a contemporary family without committing to a purely industrial look.
This pull suits designers and cabinet shops specifying a single pull that can run across an entire kitchen — doors, drawers, and island fronts — without requiring a secondary hardware choice. At 128 mm it covers the middle of the cabinet-pull size range, so it reads proportional on a standard 15-inch drawer front and is not out of place on a shaker door. It is equally well suited to a homeowner replacing worn or dated hardware on an existing cabinet layout drilled to 128 mm centers, where the priority is a straightforward swap in a current finish rather than a redrilling project. The Skyline series includes coordinating pieces for kitchens where knobs and pulls need to share a common design language.
Not quite. The center-to-center on this pull is 5-1/16 inches (128 mm), which is a distinct standard spacing. A pull drilled at a true 5-inch (127 mm) spacing is close but not identical, so confirm your existing hole centers before ordering as a replacement.
Center-to-center is the distance between the two mounting holes — the drilling dimension. Overall length is the full end-to-end size of the pull, which at 5-9/16 inches is larger than the 5-1/16 inch hole spacing. Match your existing holes to the center-to-center value, not to the overall length.
The arch refers to the shape of the grip's cross-section, not a deep curve away from the door. Projection from door face to back of grip is 1-1/16 inches (27 mm), which is a standard clearance for fingertip access.
Yes. Cabinet pulls at 128 mm centers work on drawer fronts and on door stiles, and the Skyline series is designed to run across both applications in a coordinated kitchen or bath.
At 128 mm centers in Brushed Satin Nickel, this Skyline pull gives a consistent, low-maintenance look from the first drawer to the last door without requiring a separate hardware choice at each front.
Sold In: 1 Each