Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Rinco-Matic Syma 32 Inglete profile handle is a continuous integrated grip section for handleless cabinetry, supplied in a 105-1/8 inch stock length and belonging to the SYMA Inglete32 Handle Angled series.
Where a flat Gola section creates a shadow recess at the top of a front, an angled profile handle works differently: the profile's geometry presents a shaped face that the hand angles into to pull. That angled surface is what the Inglete designation describes in the SYMA32 system. The grip is formed by the profile's own cross-section rather than by a separately attached pull, which keeps the elevation continuous and hardware-free from end to end. On a run of base cabinets or a bank of drawers, the result is an unbroken horizontal line the eye reads as a shadow rather than as a fitting.
This profile is supplied in a single stock length of 105-1/8 inches, just over eight and a half feet, and is cut down to fit the cabinet run. That dimension also means it ships as a long item rather than in a standard carton, which is worth planning for in terms of receiving and handling. The profile belongs to the SYMA Inglete32 Handle Angled series; end caps, clips, and corner pieces for the system are separate items specific to that series and are not included with the profile length.
This profile suits cabinet shops and kitchen installers building handleless elevations where the grip is integrated into the profile rather than applied on top of it. It is the right choice when a project calls for the SYMA32 Inglete system specifically, whether that is a full kitchen, a built-in wall of cabinetry, or a single run of base units where clean, hardware-free fronts are the design goal. Specifiers and designers working on contemporary interiors will find the angled form a useful alternative to a straight channel section, particularly where the grip angle is a considered part of the elevation's detail.
The angled geometry of the profile presents a shaped face that the hand angles into to pull, rather than reaching into a straight recess. The opening is still formed by the profile's own cross-section.
No. End caps, clips, and corner pieces are separate items specific to the SYMA Inglete32 series and must be ordered separately to finish the run.
It is a stock length of 105-1/8 inches (2670 mm). Cutting to the run is done on site.
The Inglete designation identifies this as an angled profile form within the SYMA32 system. Verify that the angled form matches the project specification before ordering alongside flat-profile siblings.
The Syma 32 Inglete profile handle replaces visible pulls with an integrated grip that runs the full width of the cabinet front, delivering a hardware-free elevation from the first cabinet to the last.
Sold In: 1 Each