Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rinco-Matic set closes the cut ends of a SYMA2 profile handle run in Matte Inox Champagne, and ships with the clips and screws needed to secure them.
Every SYMA2 profile handle is cut to length on site, and every cut leaves an open channel end exposed. Without a cap, that opening shows the hollow cross-section of the extrusion and collects debris. An inglete end cap closes the cut end cleanly, turning a raw cut into a finished termination that reads as part of the design. This set covers both ends of one profile run, left and right, so the run is complete from a single item.
Matte Inox Champagne sits in a warm neutral range that reads as a soft, brushed stainless rather than a bright chrome or a cool silver. It is a distinct finish from Matte Silver, Anthracite, and the other finishes in the Rinco-Matic range, and it is the correct choice when the SYMA2 profiles in the installation carry the same Matte Inox Champagne value. Finish coordination within a handleless system matters because caps and profiles sit edge to edge; a finish mismatch at the termination is visible from across the room.
This item suits a cabinet installer or kitchen designer running Rinco-Matic SYMA2 profile handles in Matte Inox Champagne and needs to finish the profile ends. It is the right choice for a single profile run that terminates at both ends without returning into a corner, where an inner or outer corner piece would be the appropriate solution instead. Confirm the SYMA size stamped or specified on the profile before ordering, since the SYMA sizes use different components and are not interchangeable.
No. This set is made for the SYMA2 profile family. Each SYMA size uses its own end cap, and they do not interchange.
Yes. The set includes a left-hand and a right-hand cap, covering both ends of one profile length.
Yes. Two clips and two screws are included, as the product name states.
No. They are separate finishes in the Rinco-Matic range. Match the finish value on your profile specification to confirm the correct cap finish.
Order this set to finish both ends of a SYMA2 profile run and keep the hardware consistent across the installation.
Sold In: 1 Set